Pelco C3425M-D manual IN-CEILING Installation 4S Deep Electrical BOX

5.Attach the surface mount ring and back box to the adapter plate with two supplied 8-32 x 2.50-inch Phillips pan head self-tapping screws.

4S STANDARD ELECTRICAL BOX

CEILING/

WALL

8-32 X 1.00-INCH	ADAPTER PLATE
PHILLIPS PAN	(SUPPLIED)
HEAD SCREWS
(SUPPLIED)

8-32 X 2.50-INCH PHILLIPS PAN HEAD SCREWS (SUPPLIED)

BACK BOX AND SURFACE MOUNT RING

Figure 9. 4S Standard Electrical Box Installation

IN-CEILING INSTALLATION: 4S DEEP ELECTRICAL BOX

1.Remove the surface mount ring from the back box (refer to Figure 5 on page 11):

a.Place fingers on the circular marks located on the sides of the surface mount ring .

b.Pinch the sides.

c.Lift and remove the surface mount ring from the back box. The ring is not required to complete the installation.

2.Attach the supplied adapter plate to the 4S box with two supplied 8-32 x 1.00-inch Phillips pan head screws.

3.Pull video and power wires through the adapter plate.

4.Connect the video cable/wires:

• BNC: Connect the BNC connector from the unit to a mating BNC connector.

• UTP: Blue wire = Video + Gray wire = Video -

C3425M-D (8/08) 15