Installation
You can install the IS90 Series Camclosure integrated camera system into any of the following:
•Mount to the surface of a ceiling/wall (refer to Surface Installation: Ceiling/Wall on page 9).
•Install in a suspended ceiling (refer to
•Install in a fixed ceiling/wall (refer to
•Mount to the surface of a 4S standard electrical box (refer to Surface Installation: 4S Standard Electrical Box on page 14).
•Install in a 4S deep electrical box (refer to
Select the best method for your installation.
UNSHIELDED TWISTED PAIR (UTP) VIDEO
The IS90 Series offers support for unshielded twisted pair (UTP). The UTP video output signal is 1
SURFACE INSTALLATION: CEILING/WALL
1.Using the template that is supplied, mark the holes on the ceiling/wall for mounting the camera system and for installing the wiring. Drill the holes. Refer to Figure 3 or Figure 4.
2.Pull video and power wires through the ceiling/wall.
3.Connect the video cable/wires:
•BNC: Connect the BNC connector from the unit to a mating BNC connector.
•UTP: Blue wire = Video +
Gray wire = Video -
4. Connect the power wires.
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | ~ | ~ |
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
5. For a
9 |