Rosewill RXS-3323 Fcc Statement, FCC RF Radiation Exposure Statement, CE Mark Warning, Country

Page 2

Internet Camera RXS-3323/RXS-4324

User Manual

 

 

 

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

National Restrictions

2400.0-2483.5 MHz

Country

Restriction

Reason/remark

Bulgaria

 

General authorization required for outdoor use and public service

France

Outdoor use limited to 10 mW EIRP.

Military Radiolocation use. Refarming of the 2.4 GHz band has

 

within the band 2454-2483.5 MHz

been ongoing in recent years to allow current relaxed regulation.

 

 

Full implementation planned 2012

Italy

 

If used outside of own premises, general authorization is

 

 

required

Luxembourg

 

General authorization required for network and service

 

 

supply(not for spectrum)

Norway

Implemented

This subsection does not apply for the geographical area within a

 

 

radius of 20 km from the centre of Ny-Ålesund

Russian

 

Only for indoor applications

Federation

 

 

Note: Please don’t use the product outdoors in France.

2

Image 2
Contents Wired Internet Camera RXS-3323 Wireless Internet Camera RXS-4324 User ManualCE Mark Warning FCC STATEMENTFCC RF Radiation Exposure Statement National RestrictionsChapter 3. Connecting to the Camera Table of ContentChapter 2. Installation Chapter 1. Product OverviewAppendix A Restore Factory Default Settings 5. RJ 45 Cable 6. 12V/1A Power Adapter 7. Camera Mount Kit Package Contents3. Quick Installation Guide Chapter 1. Product Overviewz H2.64, MPEG4, and MJPEG Tri-Codec supported Product FeaturesSystem Requirements z 2-Way Audio Capabilityz Optimal Viewing z Remote Control SupportedHighlights z Supports Multiple Profileseasily Power and Wireless Introduction of HardwareFront View IR LEDsAntenna Connector Rear ViewPower Jack Factory Default ResetChapter 2. Installation Hardware InstallationCamera LAN and Power Installation Ceiling MountWall Mount Software InstallationIPWizard II Installation 3.Please click on “IPWizard” under “Software & Tools” to continue 4.Click on “Run” to continue7.Click on “Finish” to finish the installation 6.Click on “Next” to continuemanagement page in your default Web Browser Using IPWizardChapter 3. Connecting to the Camera Double Click on the above information bar will open up the CameraOne click to view the 9. Wireless14. WiFi video from theWireless Page You should see the confirmation Status Window popup as below. Please select “OK” to confirm these settings Internet Camera RXS-3323/RXS-4324 Managing the Camera Access the device using IE for the first timeThree ways to access the Camera for the first time Opening up UPnP in Win XPOpening up Network Discovery in Win7 z Open Control Panel z Click on Network and Internetz Click on View Network Computers and devices Entering into Camera’s Management page via IE z Upon selecting the “Install This Add-on for All User on This Computer”, you will see an Security Warning Window asking your permission to install the Rosewill Media Control. Please click “Install” to continute Streaming Management PageSettings LanguageRecord 10. VolumeSnapshot 11. StatisticsChapter 4. Managing the Device SettingNetwork Network8. Secondary DNS 9. HTTP Port 1. MAC address 2. Obtain IP address automatically DHCP 3. IP address4. Subnet mask 5. Gateway 6. Obtain DNS from DHCP 7. Primary DNS 4. Interface Select 5. Type Wireless1. Setting Easy Installation 2. Site survey 3. MAC address 8. Channel 6. SSID7. BSSID 9. Security modeDDNS 1. DDNS 2. Server name 3. DDNSHost 4. User name 5. Password1. PPPoE 2. User name 3. Password PPPoEStreaming 4. IP address, Subnet mask, and Gateway read only 5. StatusUPnP 1. RTSP Port 2. RTP Port1. UPnP 2. Friendly Name 3. UPnP NAT Traversal 4. Port Range BonjourIP Filter 5. External IP addressIP Notification 1. SMTP Notification e-mail 2. Send To 3. Subject8. HTTP Notification 9. URL 10. HTTP Login Name CameraPicture 11. HTTP Login Password 12. Proxy Address 13. Proxy PortLED ON Threshold 0~10000 2. White Balance 3. Exposure Control 4. Color Level 5. Brightness6. Sharpness 7. Contrast 8. Night Mode 9. White-Light LED LED OFF Threshold 0~1000010. De-Noise Preset SettingTour Setting 1. Tour Name 2. Running 3. Preset 4. Wait Time SystemSystem 1. DIPS Dynamic IP Service 2. Device ID for DIPS3. Adjust Date & Time6. Power LED Wireless LED 7. Log 8. Reload 3. Device Title 4. Software Version 5. Network LED2. Factory Default Except the network setting 3. Backup Setting Maintenance1. Hard Factory Default Include the network setting 4. Restore Setting5. Firmware Upgrade procedure 6. System RestartVideo Profile VideoCommon 1. Text Overlay Setting 2. Video Profile4. GOP Control ROI 0 The area size of ROI 0 is H.264 / VGA, 640 x ROI 1 The area size of ROI 1 is H.264 / QVGA, 320 x1. Audio 2. Audio Mode 3. Input Gain 4. Output Gain AudioUser 1. SMTP Server 2. Test 3. SMTP Port 4. SMTP E-Mail3. Add, update, and remove of Users account 7. E-mail To 8. E-mail From 9. E-mail Subject Object DetectionAuthentication 5. Authentication User name 6. Authentication Password 1. Add and Del 2. Included or Excluded Window 3. Name 4. Object SizeTCP Server Event ServerFTP Server 1. Name 2. FTP Server 3. Test 4. FTP Login name 5. FTP Login Password1. Name HTTP Server1. Name 2. TCP Server 3. TCP Port 6. Proxy Address 7. Proxy Login name 8. Proxy Login Password SAMBA Server2. URL 3. Test 4. HTTP Login name 5. HTTP Login Password 1. Name 2. SAMBA Server 3. Test 4. SAMBA Login name 5. SAMBA LoginPassword 6. SAMBA Path SettingEvent Schedule 1. Name 2. Enable 3. Type 4. Enable Time 5. Trigger by 6. ActionRecord 1. Record File Type 2. Record File Prefix 3. JPEG Picture Numbers2. PTZ Adding Preset pointAdvance PTZ 2. Please right click on it and select “Temporarily Allow Scripted Windows” Selecting Tour Digital ZoomSnapshot Volume RecordAppendix A Restore Factory Default Settings Restore the deviceInstall the Device Appendix B Troubleshooting & FAQFeatures QuestionAccess the Device UPnP ConnectionNetwork Camera’s private IP address Video Quality of the Device Miscellaneous Appendix C Ping IP Address Average range of data sizes Appendix D Bandwidth EstimationImage Resolution Average bit rate forAppendix E Specifications 0 ~ 355 180/ second MAX 1 Assign a local/fixed IP address to your device Appendix F Configure Port Forwarding Manually2 Access the Router with Your Web browser 3 Open/set Virtual Server Ports to enable remote image viewing Your WAN IP will be listed herePort section, click Apply 1 Environment of Fixed Valid IP Network Appendix G DDNS ConfigurationProcess of set up your own Domain Name 2 Environment of Dynamic IP Network4. Fill the application agreement and necessary information c. Password and confirmation3. After the columns show up at the left side, click “Create Account” a. Username b. E-mail address and confirmationInternet Camera RXS-3323/RXS-4324 8. Click the “Services” 9. Click the “ Dynamic DNS ”10. Click the “Get Started” Appendix H 3GPP and iPhone iPhone
Related manuals
Manual 14 pages 54.86 Kb