Rosewill RXS-4324 Ssid, Bssid, Channel, Security mode, Obtain IP address, automatically, Dhcp

Internet Camera RXS-3323/RXS-4324User Manual

6. SSID:	This is the name of the wireless network the device is configured for. The field accepts
	up to 32 alphanumeric characters. The name must be exactly the same as that used in the
	wireless access point, or the connection will not be established.
	Leaving this field blank means the device will attempt to access the nearest open
	network.
7. BSSID:	This is the MAC address of the wireless AP detected.
8. Channel:	You can choose the wireless channel that you currently using.
9. Security mode:	This shows which type of security the network uses. The device supports three security
	methods: None, WEP, and WPA_PSK/WPA2_PSK.
	- WEP settings:
	- Authentication:
	Select Open or Shared Key System Authentication, depending on the method used
	by your access point. Not all access points have this option, in which case they
	probably use Open System, which is sometimes known as SSID Authentication.
	- WEP Mode:
	The key types available depend on the access point being used. The following
	options are available:
	„ ASCII - In this method the string must be exactly 5 characters for 64-bit WEP
	and 13 characters for 128-bit WEP.
	„ HEX - In this method the string must be exactly 10 hexadecimal (0-9, A-F)
	characters for 64-bit WEP and 26 hexadecimal characters for 128-bit WEP.
	- Web Key 1~4:
	Key-in the password of WEP.
	- WPA_PSK/WPA2_PSK settings:
	- WPA Key:
	Key-in the password of WPA. The device uses a pre-shared key (PSK) for key
	management. The pre-shared key can be entered either as Manual hex, as 64
	hexadecimal characters, or as a Passphrase, using 8 to 63 ASCII characters.
11. Obtain IP address	Enable this checked box when a DHCP server is installed on the network to issue IP
automatically	address assignment. With this setting, the IP address is assigned automatically.
(DHCP):
12. IP address, Subnet	If you do not select Obtain an IP address automatically, then you need to enter these
mask, and Gateway:	network parameters manually.
	Select “OK” to save and enable the setting.

Note: To enable WLAN function, user must set these related parameters correctly at first. Then power off the device and remove Ethernet cable from device. Power on the device again and WLAN mode will be available accordingly.

31