INSTALLATION INSTRUCTIONS
INSTALLATION
5.8 Log & Driftwood Layout – Medium Chamonix, Large Aspen & Chamonix
It may be necessary to make small changes to the log positioning in order to achieve the most pleasing flame effect but the following guidelines should be followed.
5.8.1Refer to the log identification chart and identify the numbers corresponding to the logs that have been supplied. See diagram 23.
23
8
5.8.2Place the two logs (No.13) on top of the beads as shown. See diagram 24.
24
AR1278
5.8.3Place the large log (No. 1) so that it sits on top of the previous two logs. Place the burnt effect log (No. A1) in the centre of the tray as shown. Place one log (No. 7) along each side of the tray, another log (No. 7) along the front LH side and a log (No. 8) along the front RH side of the tray. See diagram 25.
25
AR1279
5.8.4Place two cones (No. 14), one in the RH front corner and the other at the LH side of the burnt log. See diagram 26.
26
AR1280
5.8.5Place one large log (No. 6) so that it rests on top of the rear and front logs to the LH side. Place the other large log (No. 6) so that it rests on top of the rear and front logs on the RH side and log (No. 8) so that it bridges the centre gap as shown. See diagram 27.
27
AR1281
20