4
Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
FILL TANK & CONNECT POWER
A | ■ Turn on the cold water supply. | |
| ■ Depress the cold faucet handle | |
| and hold it until water flows from | |
| the spout. | |
| ■ Allow water to run for at least | |
| 60 seconds after water begins to | |
| flow from faucet. | |
Property Damage: Before plugging in | ■ Depress the hot water handle until | |
chilled water tank, check for leaks in all | water flows smoothly. | |
water supply connections. | ||
|
B
Property Damage: A standard grounded
outlet is required under the sink.
Do not use an extension cord set with
the chilled water tank.
■Check all connections to ensure they are tight and that there are no leaks.
■Plug in chilled water tank and hot water dipenser tank.
■Prior to drinking water from the chilled water tank, run the water for at least 5 minutes to flush lines.
Allow up to 60 minutes for
water to reach target temperature.
Gurgling or hissing is normal during the initial heating cycle.
The SinkTop Switch™ from InSinkErator® conveniently switches power between two electrical outlets, which allows the chilled water tank, hot water dispenser and food waste disposer to be connected to the same electrical outlet. The chilled water tank should not be plugged into the SinkTop Switch. The chilled water tank must be connected directly into the open wall outlet. For more information visit www.insinkerator.com.
6