InSinkErator CWT-00, F-C1100 owner manual What YOU should Know Before YOU Begin

Congratulations on your purchase of this quality InSinkErator® water product. In addition

to complete operating and care instructions, in this Owner’s Manual you will find instructions for installing both:

•CWT-00 Chilled Water Tank with an existing hot/cool water dispenser – See pages 4-6

•CWT-00 Chilled Water Tank with a C1100 Cold Only Faucet – See pages 7-9

WHAT YOU SHOULD KNOW BEFORE YOU BEGIN

■IMPORTANT: After unpacking chilled water tank, place the unit upright for 1 hour before connecting power.

■For best results, the cold water faucet should be installed prior to installing the chilled water tank.

■For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this chilled water tank.

■This particular unit is not intended for commercial use.

■Make sure that all electrical wiring and connections conform to local codes.

■A standard 120-volt grounded electrical outlet is required under the sink for the chilled water tank’s electrical power.

■It is recommended that a separate circuit providing power only to the chilled water tank be used.

■The wall outlet powering the chilled water tank must be fused and should not be controlled by the same wall switch used by the food waste disposer.

■It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system. Make sure all water supply control valves do not have a backflow preventer in them.

■If you suspect elevated levels of chlorine in your water, it is recommended to use our water filtration system.

■The water pressure to the chilled water tank should be between a minimum of 30 psi (207kPa) and a maximum of 100 psi (689kPa).

■The chilled water tank may cause an increase in temperature in your cabinet when running.

■The chilled water tank has a refrigeration compressor, which may generate noise while running.

■The chilled water tank should only be installed in an upright position.

■The chilled water tank is intended only for chilling water.

WHAT YOU NEED TO GET STARTED

Equipment Required: (sold separately)

■ Cold water faucet	■ Adjustable wrench
■ T-fitting	■ Utility knife
■ Dedicated control valve	■ Tape measure / ruler
Equipment You May Need:	■ Hole saw / hole punch ■ Basin wrench

If you will be installing a dedicated cold only water faucet and intend to use the sprayer hole in your sink for that faucet, you may need a basin wrench and a 1/8" plug or a 1/4" hose line cap (not supplied).

If you need to cut a mounting hole in your stainless steel sink, you may need a 11⁄4" - 11⁄2" hole saw made for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other than stainless steel.

2