2
Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
INSTALLING THE WATER TANK
A
Inlet 
Property Damage: All tubes must be cut
squarely with no burrs.
■Attach supplied quick connect elbow to end of supplied white 1/4" tube.
■Attach quick connect elbow to water Inlet on front of chilled water tank.
■Measure distance from water inlet on chilled water tank to water supply valve (See Step 3). Carefully trim white 1/4" tube, allowing ample slack in tubing.
B
Outlet 
White Tape
Property Damage: Do not pinch or break tubing.
Do not distort the last 1 inch of tubing.
Pull on connection to ensure fully engaged.
■Attach supplied quick connect elbow to end of supplied blue 1/4" tube.
■Attach quick connect elbow with blue tube to water Outlet on front of chilled water tank.
■Measure distance from the chilled water tank outlet to water supply line on faucet. Carefully trim blue tube to correct length.
■Using quick connect elbow, connect remaining end of blue tube to unmarked copper tube coming from faucet.
3
WATER CONNECTION
A | From filter or |
water supply | |
| Brass Nut |
| Ferrule |
| Brass Insert |
Property Damage: Join remaining tube to cold water supply only. Water supply valves must not prevent backward flow.
■Install a
■Install dedicated water control valve with 3/8" compression fitting.
■Install brass nut, ferrule and tube insert on to white 3/8" tube which runs from filter or “Y”
■Insert the white 3/8" tube into the 3/8" compression fitting and tighten.
B |
| To hot water | |
| dispenser | ||
White Tape | |||
| |||
From filter or
To chilled waterwater supply tank “Inlet”
To remove tube(s) or plug from
■Remove existing “Y” quick-connect fitting and discard.
■Connect white 3/8" tube from the filter or water supply into the supplied “Y”
■Insert 1/4" white tube from tank inlet into the 3/8" to 1/4"
■Identify copper HOT water tube, which is marked with white tape. Install that tube into the 3/8" to 1/4"
5