Install a T-fitting not included | InSinkErator F-C1100, CWT-00

Follow these steps for installing chilled water tank with a cold only faucet.

A	With no filtration system:
A	■ Install a T-fitting (not included)
	onto the cold water supply line.
To “Inlet” on front of	■ Install dedicated water control valve
chilled water tank	with 1/4" compression fitting.
	with 1/4" compression fitting.
	■ Attach remaining end of the supplied
	white 1/4" tube into the 1/4"
	compression fitting and tighten.
Property Damage: Join remaining tube
to cold water supply only. Water supply valves
must not prevent backward flow.

A Brass Nut

Ferrule

Brass Inse

Property Damage: Join remaining tube

to cold water supply only. Water supply valves

must not prevent backwards flow.

For filtration installation instructions, see installation guide packed with the system.

Install a T-fitting (not included) onto the cold water supply line.

Install dedicated water control valve with 3/8" compression fitting.

Install brass nut, ferrule and tube insert at the end of the white 3/8" tube from filter.

Insert the white 3/8" tube into the 3/8" compression fitting and tighten.

A	■ Turn on the cold water supply.
	■ Depress the faucet handle and
	hold it until water flows from the
	spout.
	■ Allow water to run for at least 60
	seconds after water begins to flow
	from faucet.
	Property Damage: Before plugging in
	chilled water tank, check for leaks in all
	water supply connections.

Property Damage: A standard grounded outlet

is required under the sink. Do not use an

extension cord set with the chilled water tank.

■Check all connections to ensure they are tight and that there are no leaks.

■Plug in chilled water tank.

■Prior to drinking water from the chilled water tank, run the water for at least 5 minutes to flush lines.

Allow up to 60 minutes for

water to reach target temperature.

■ Install a T-fitting (not included)