®
STEP 5 - WIRING THE FAN
1.Disconnect the power by turning off the circuit breakers to the out- let box and associated wall switch location.
2.Tilt and hang the assembled fan from the ceiling plate hooks. Slip two rectangular canopy slots over ceiling plate hooks as shown in Figures 5a and 5b.
Note: To hang the fan you must tilt the canopy to an almost verti- cal position so the canopy slots come down over the ceiling plate hooks.
3. You can use either one or two |
wall switches to control the fan |
and/or lights separately. Use con- |
nection 1 on page 14 to |
• control the light with a wall |
switch and the fan with a |
chain pull (one wall switch re- |
quired) |
• control the light with a chain |
pull and the fan with a wall |
switch (one wall switch re- |
quired) |
• control the light with one wall |
Ceiling
Plate
Figure 5b - Assembled Fan Hanging
Figure 5a - Attaching Slots on Canopy from Ceiling Plate Hooks to Ceiling Plate Hooks
41545-01 6/10/2002
switch and the fan with an- |
other (two wall switches re- |
quired) |
Use connection 2 on page 14 if there is no separate wall switch power wire for the light fixture.
Note: Wall switches not included.
continued
13