Hunter Fan 41545 operation manual Attaching the Switch Housing, Attaching the Upper Switch Housing

®

STEP 8 - ATTACHING THE SWITCH HOUSING

The switch housing is made up of two sections: the upper switch hous- ing, and the lower switch housing.

ATTACHING THE UPPER SWITCH HOUSING

1.Partially install two #6-32 x 3/8" housing assembly screws into the switch housing mounting plate as shown in Figure 8a.

Switch	Housing
Housing	Assembly
Mounting	Screw
Plate	Upper Plug
	Connector
Upper
Switch
Housing

Figure 8a - Attaching Upper Switch Housing to Switch Housing Mounting Plate

2.Feed the upper plug connector through the center opening of the upper switch housing. See Figure 8a.

3.Align the keyhole slots in the up- per switch housing with the hous- ing assembly screws installed in sub-step 1.

4.Turn the upper switch housing counterclockwise until the hous- ing assembly screws are firmly situated in the narrow end of the keyhole slots as shown in Figure 8b. Install the one remaining #6- 32 x 3/8" housing assembly screw into the third hole in the upper switch housing. Tighten all three screws firmly.

CAUTION

Make sure the upper switch hous- ing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three housing assem- bly screws could result in the switch housing and light fixture falling.

Figure 8b - Mounting the Upper Switch Housing

41545-01 6/10/2002

18