®
STEP 4 - ASSEMBLING THE FAN
Use the Step 4 instructions for the type of mounting you have selected: standard, angle, or flush.
STANDARD AND ANGLE
MOUNTING
For Standard
1.Insert the pipe through the canopy as shown in Figure 4a.
Pipe
Canopy
Pipe
Setscrew
Figure 4a - Inserting Pipe through Canopy
Feed wires from the fan through the pipe.
2.Screw pipe into fan assembly un- til tight. IMPORTANT! Tighten pipe setscrew as shown in Figure 4a.
CAUTION
The pipe has a special coating on the threads. Do not remove this coating; the coating prevents the pipe from unscrewing. Once as- sembled, do not remove the pipe.
FLUSH MOUNTING
For Low Ceilings
1.Fit the canopy over the motor hanger adapter as shown in Fig- ure 4b. Make sure the canopy fits snugly against the fan assembly
with no space between the pieces.
2.You will find a large assembly washer included with the fan. Place the washer over the adapter and canopy as shown in Figure 4b.
Assembly
Washer
Canopy
Adapter
Top of Fan
Figure 4b - Placing Canopy and Washer Over Adapter
continued
41545-01 6/10/2002
11