®
STEP 2 - INSTALLING THE CEILING PLATE
1.Drill two pilot holes into the wood support structure through the outermost holes on the outlet box. The pilot holes should be 9/64" in diameter.
2.Thread the lead wires from the outlet box through the hole in the middle of the ceiling plate.
3.Your fan comes with two neo- prene noise isolators. Position the isolators between the ceiling plate and ceiling by inserting the raised areas on each isolator into the holes in the ceiling plate. Refer to Figure 2a.
Isolators
Ceiling
Plate
Figure 2a - Adding Isolators to Ceiling Plate
4.Align the slotted holes in the ceil- ing plate with the pilot holes in the wood support structure. Note: The isolation pads should be flush against the ceiling.
For Angle Mounting Only: Be sure to orient the ceiling plate so that the two hooks point up to- wards the ceiling peak as shown in Figure 2b. Note: You will use the hooks to support the fan dur- ing STEP 5 - WIRING THE FAN.
Ceiling Plate
Hooks
Figure 2b - Correct Position of Ceiling Plate for Angle Mounting
41545-01 6/10/2002
8