Samsung UE49KS8080TXZG, UE43KS7590UXZG manual Schedule Recording/Timeshift Function Isnt Working

The Schedule Recording/Timeshift Function Isn't Working

When Timeshift or Schedule Recording aren't working, these steps may help resolve the problem.

The problem	Try this!
	Check if there is a USB device connected to the TV.
Schedule Recording cannot be	Recording will automatically stop if the signal becomes too weak. The
used.	Timeshift function will not work if there isn't enough storage space on the
	USB device.

Anynet+ (HDMI-CEC) Isn't Working

When Anynet+ (HDMI-CEC) isn't working, these steps may help resolve the problem.

The problem		Try this!
	Confirm that the device is an Anynet+ device. The Anynet+ system supports
	Anynet+ devices only.
	Check if the power cord of the Anynet+ device is properly connected.
	Check the cable connections of the Anynet+ device.
	Go to Anynet+ (HDMI-CEC) (	Settings System Expert Settings
Anynet+ does not work.	Anynet+ (HDMI-CEC)) and see if Anynet+ (HDMI-CEC) has been set to On.
	Check whether the TV remote control is in TV mode.

Check whether the remote control is Anynet+ compatible.

	Anynet+ may not function when some other functions are active, including
	Channel Search, Smart Hub, Plug & Play, etc.
	If you have disconnected and then reconnected the HDMI cable, scan for
	devices again or turn your TV off and on.
	Check if the Anynet+ device is properly connected to the TV, and then select
I want to start Anynet+.	the Anynet+ (HDMI-CEC) (	Settings System Expert Settings
	Anynet+ (HDMI-CEC)) menu to see if Anynet+ (HDMI-CEC) is set to On.
I want to exit Anynet+.	Set Anynet+ (HDMI-CEC) (	Settings System Expert Settings
	Anynet+ (HDMI-CEC)) to Off.
The message "Connecting	You cannot use the remote control when the TV is configuring Anynet+
to Anynet+ device..." or
	or switching to a viewing mode. Use the remote control after the TV has
"Disconnecting from Anynet+
	completed the Anynet+ configuration or has switched to a viewing mode.
device" appears on the screen.
The Anynet+ device won't	You cannot use the play function when Start Setup is in progress.
play.

Check whether the device supports Anynet+.

Check whether the HDMI cable is properly connected.

	Go to Anynet+ (HDMI-CEC) (	Settings System Expert Settings
	Anynet+ (HDMI-CEC)) and see if Anynet+ (HDMI-CEC) has been set to On.
The connected device is not	Scan for Anynet+ devices again.
displayed.	Anynet+ devices must be connected to the TV using an HDMI cable. Make sure
	the device is connected to your TV with an HDMI cable. Some HDMI cables may
	not support Anynet+.
	If the connection is terminated because there has been a power failure or the
	HDMI cable has been disconnected, please scan for the device again.