Samsung SHR-5040P/CZC, SHR-5042P manual Camera,  Hdd End,  HDD END Alarm, Checking HDD Data

HDD Format

When initializing the HDD, move the cursor to the corresponding HDD and press the Enter( ) button. Then, the (Format) icon is activated.

If you press “Format”, the HDD format window appears. You can select “OK” to initialize the HDD.

HDD END

Stop: Recording stops when the HDD becomes full while in recording.

OverWrite: If the HDD becomes full while in recording, the data recorded at the earliest time will be deleted and new data will be written.

HDD END ALARM ()

On: If the HDD becomes full while in recording, it gives an alarm.

Off: If the HDD becomes full while in recording, it does not give any alarm.

If the HDD space is not enough, the Disk_Full ( ) icon appears.

	 Because all data will be deleted when
Caution	the HDD formatting is executed, please
	proceed with the initialization after
	backing up important data to other
	place.
	 If the repeated HDD recording is set to
	“OverWrite” and the data to be backed
	up are overwritten, either the backup
	start time can be changed or the
	backup is cancelled.
	Checking HDD Data
Caution	Please, pay attention to Following
	information to minimize the chance of
	losing HDD data.
	 Remember that you should protect HDD
	from any impact or misuse as this may
	cause damaged.
	 The Manufacturer is not responsible for
	missing data or defects caused by the
	user’s mishandling.
	Note: Adding Extra HDD.
	Check in advance that the HDD is
	compatible with the manufacturer’s DVR.
	Examples that can cause loss of data or
	damage HDD.
	 Any outside Impact on the case which
	could happen whilst disassembling or
	setting up the DVR.
	 Power cut or incorrect shutdown whilst
	the DVR is operating. (Refer to page 27:
	how to turn off DVR)
	 Moving or causing any impact on the
	DVR during operation.
	Please, back up events as soon as
	possible to minimize disappointment
	should HDD data be lost.

System Shutdown

System Shutdown

Sure to shutdown?

	OK	Cancel
Move/Control	Select	Exit

This function is used when either terminating the running jobs safely or turning off the power.

If you see the system shutdown message after pressing “OK” on the confirmation window, turn off the power.

	 If the system is turned off without
Caution	terminating it using the system shutdown
	menu, it may cause a problem such as
	data loss and disk failure. When turning
	off the power, please terminate the
	system first using the system shutdown
	menu.

CAMERA

The details of the camera menu are as follows:

SHR-5042/5040 MENU

System	►
Camera	►	Camera Configuration
		PTZ Device
Monitoring	►
		Screen Setup
Record Mode
Event Record	►
Record Schedule
Backup
Network	►
Move/Control		Select	Exit

menu setup _27

05 MENU SETUP