Samsung SHR-8160P Setting the Protocol, Move to Connection Mode, and press Enter, Select Protocol

using the DVR

•IP, Gateway, Subnet Mask, and DNS

-For <Static IP> : You can directly input IP address, Gateway, Subnet Mask and DNS.

-For <Dynamic IP> : IP address, Gateway, and Subnet Mask are set automatically.

-For <ADSL> : IP address, Gateway, and Subnet Mask are set automatically.

•User ID, Password : In case you selected ADSL, provide the “User ID” and its “Password”.

Connection Mode

Connection		Protocol
	Connection Mode	ADSL
	Bandwidth
		600kbps
	IP	192.168. 1.200
	Gateway
		192.168. 1.	1
	Subnet Mask
		255.255.255. 0
	DNS
		Manual		168.126. 63. 1
	User ID	ID
	Password
		********
		OK		Cancel

M DNS server for <Dynamic IP> and <ADSL> can be set by user only if you selected <Manual>.

6.When the connection setup is done, press <OK>.

Setting the Protocol

3.	Use the up/down buttons (▲▼) in <Network> window to	Connection Mode
	move to <Connection Mode>, and press [ENTER]
		Connection	Protocol
	button.
		Protocol Type		TCP
4.	Select <Protocol>.	Port(TCP)
				554 ~ 557
		Port(UDP)
				8000 ~ 8159
		Unicast/Multicast
5.	Use direction buttons (▲▼◄ ►) to move to a desired			Unicast
		Multicast IP
				224.126. 63. 1
		TTL
	item, and set the value.			5
		Webviewer Port
				80

•Protocol Type : Select the protocol type between TCP and

UDP. OK Cancel

If selected UDP, selections of Port (TCP), Port (UDP), and Unicast/ Multicast are activated.

•Port (TCP) : Initially, <554~557> is set. It increases / decreases by 4.

- TCP: It has better stability and lower speed when compared to UDP, and recommended for internet environments.

•Port (UDP) : Initially, <8000~8159> is set. It increases / decreases by 160.

- UDP : It has less stability and faster speed when compared to TCP, and recommended for local area network (LAN) environments.

•Unicast, Multicast : Select one between Unicast and Multicast. If selected Multicast, Multicast IP and TTL are activated.

- Unicast : Transfers data (UDP, TCP) individually to each connecting client.

- Multicast : Multiple client can receive the data (only in UDP) without putting additional traffi c load to the network.

•Multicast IP : User can directly input.

•TTL : Select from 0 ~ 255. Initial value for the TTL is set to <5>.

•Webviewer Port : Enter the port number for the Web Viewer. Initially, it is set to <80>.

6.When the protocol setup is done, press <OK>.

56_ using the DVR