Samsung AQV09EWEN manual Cleaning the air conditioner, Cleaning the indoor unit, Opening the panel

Page 17

Cleaning the air conditioner

•Make sure the power is turned oﬀ and unplugged from

the wall socket when cleaning the air conditioner.

Cleaning the indoor unit

Wipe the surface of the unit with a slightly wet or dry cloth when needed.

• Contact the service center when you clean the indoor unit

heat exchanger because it needs to be disassembled.

• Do not clean the display using alkaline detergent.

• Do not use sulfuric acid, hydrochloric acid, organic solvents (such as thinner, kerosene and acetone etc.) to clean the surface of the product or put any stickers on it. They may damage the surface of the air conditioner.

Cleaning the outdoor unit heat exchanger

When dust accumulates on the heat exchanger, it may decrease cooling performance. Therefore, clean it regularly.

Spray water to clean the dust.

• If it is difficult to clean the outdoor unit heat exchanger on

your own, contact service center.

•Be careful with the sharp edges on the outdoor unit heat exchanger.

ENGLISH

Heat exchanger

(Illustration may differ slightly depending on the models)

Opening the panel

Tightly grab top of the front panel and pull it down to open.

Then slightly lift the panel up.

17

Vivaldi Cystal EUR_AQV09E@@ IB&IM_32449A_E.indd 17

2011-3-7 15:45:08

Image 17

Contents Vivaldi Cystal EURAQV09E@@ IB&IM32449AE.indd 2011-3-7 Contents Important safety symbols and precautions Safety precautionsFollow directions Wall socketFor Using For Cleaning Operation ranges Checking before useChecking the name of the parts PowerMain parts DisplayRemote controller buttons Checking the remote controllerBattery changing time Remote controller displayStoring the remote controller Inserting the batteriesBasic function Press Button to adjust the temperatureUsing the Turbo function Adjusting the air flow directionPress the Air swing button on the remote controller Vertical air flowPress the button on the remote controller When the air conditioner is on and in cool/heat modePress the Set/Cancel button to active it on ModePress the On Timer/Oﬀ Timer button to set the time Setting the On/Off timerPress the On Timer/Oﬀ Timer button Using the Smart Saver function Using the SPi functionUsing the Auto Clean function Using the Quiet functionWhen the air conditioner is turned on You can reduce the noise generated from an indoor unitCleaning the indoor unit Cleaning the air conditionerCleaning the outdoor unit heat exchanger Opening the panelRemoving the Air filter Cleaning the air filterOpen the panel and put the Air filter out Dry the Air filter in a ventilated areaPeriodical checks Maintaining the air conditionerTroubleshooting Connection Outdoor unit Heat exchanger during Heat mode in winterFlow movement changes. It is normal AQV09E, AQV12E, AQV18E, AQV24E General informationIncluded Models Remark Installing the unit Choosing the installation locationPower supply line, fuse or circuit breaker  a place where the air filter can be replaced easilyOutdoor Unit Where sulfide gas existsWhen the air outlet is towards the wall When installing more than 1 outdoor unit Figure Description Top view Side viewAccessories in the outdoor unit case AccessoriesAccessories in the indoor unit case Optional accessories Fixing the installation plateTools required for installation General Tools Tools for test operationsConnecting the cable Connecting the assembly cableCable specification Each wire is labeled with the corresponding terminal number Cut off the remaining foam insulation Smooth the cut edgesCutting or extending the pipe Purging the indoor unitUnscrew the caps at the end of each pipe Put a flare nut slightly into the pipe and modify the flareCorrect Inclined Pipe 50 Pa. The joint must be accessible and serviceableCracked Outer DiameterDrain hose installation Ensure that condensation draining is adequate Purging the connected pipesConnect a drain hose to the drain plug Adding Refrigerant 1975 Please fill in with indelible ink the factory refrigerant charge of the product To check for gas leaks on the outdoor unit Performing the gas leak testsTo check for gas leaks on the indoor unit Leak test with nitrogen before opening valvesThen place the indoor unit on the installation plate Outdoor unit installed on the wall by rackFixing the indoor unit in place Fixing the outdoor unit in placeFinal Check and Trial Operation Apply heat to the contraction tube to contract it How to connect your extended power cablesAfter tube contraction work is completed, wrap it with Insulation tape to finishEnglish 7267864, € 0.07/min 42 2770 70 19 +381Air Conditioner

Related manuals

Manual 23 pages 41.95 Kb

Manual 23 pages 55.9 Kb

Manual 25 pages 14.93 Kb

Manual 39 pages 27.14 Kb