Samsung SNR-1162P/XET manual Ptz

•Video Channel

If the camera supports multiple channels, select a video channel. (e.g. AXIS 240Q)

•Audio Channel

If the camera supports multiple channels, select an audio channel.

•Enable Audio

Select this option to record audio.

•Encoding Type

If encoding type can be set, select either MJPEG or MPEG4.

•Resolution

Select camera resolution.

•FPS

Select the number of frames per second to be transmitted over the network. (1 ~ 30 )

The number of transmitted video frames may be less than the specifi ed number depending on the network condition.

•I Interval

Shows the I frame interval.

For example, if <I Interval> is "30", 30 P frames are inserted into one I frame.

•Rate Control

Shows recording mode of the camera. (CBR (Constant Bit Rate), VBR (Variable Bit Rate)).

•Video Quality

If the camera allows video quality setting, select a desired video quality. (0 (lowest) ~ 100 (highest))

•Max Bit Rate

Shows the maximum data rate of the camera. VBR (Variable Bit Rate)

•Bit Rate

Shows the data rate of the camera. CBR (Constant Bit Rate)

•Deinterlace

Removes the after image of the shaded area of the picture from the camera.

•Noise Filter

Reduces noise in the picture from the camera.

•Watermark

Used to prevent video forgery.

➁Custom Setup

You can check the connection status through the web browser installed on the network camera.

For the active-X IP camera, you can check the connection status but you can not view the camera input or are not enabled to confi gure the camera settings.

J For more information on camera setting, refer to the manual supplied with the camera.

PTZ

In <Camera>, select PTZ protocol and set up PTZ Preset in the PTZ tab.

1.Click <PTZ preset> of PTZ camera.

2.The preset setting window appears and you can set up to 12 camera presets.

J For more information on registering and deleting presets, refer to the descriptions in the setting remote PTZ camera section.

 CONFIGURATION MODE

English _47