Samsung RZ2993ATCWW/ES manual Setting up your freezer, Getting Ready to Install the Freezer

setting up your freezer

GETTING READY TO INSTALL THE FREEZER

Congratulations on your purchase of this Samsung Freezer. We hope you enjoy the state-of-art features and effi ciencies that this new appliance offers.

•This freezer must be properly installed and located in accordance with the manual before it is used.

•Use this appliance only for its intended purpose as described in this instruction manual.

•We strongly recommend that any servicing be performed by a qualified individual.

•Please dispose of the packaging material for this product in an environmentally friendly manner.

Pull the power plug out of the socket before WARNING changing the interior light of the freezer.

-Otherwise, there is a risk of electric shock.

Selecting the best location for the Freezer

•A location without direct exposure to sunlight.

•A location with flat floor surface.

•A location with enough space for the freezer door to open easily.

•Allow sufficient space for air circulation of the internal cooling system. If the freezer does not have enough space, the internal cooling system may perform more.

100 mm

1800 mm

or

1650 mm

50 mm

• Height of the product may be different
depending on the models.
• Allow clearance to the right, left, back and top
when installing. This will help reduce power
consumption and keep your energy bills lower.
• Do not install the freezer in a place with the	01
temperature lower than 10°C.
	SETTING
Pull the unit straight out when installing,
CAUTION servicing or cleaning behind the freezer and
push it straight back after work is complete.
Make sure your fl oor can support fully loaded	UP
freezer.

REVERSING THE FREEZER DOOR

Samsung recommends that reversing of the door WARNING opening is only completed by Samsung approved

Service providers. This will be on a chargeable basis and at the customers expense.

Any damage caused while attempting to reverse the door opening is not covered under the appliance manufactures warranty. Any repairs requested due to this circumstance will be completed on a chargeable basis at the customers expense.

Required Tools (Not provided)

Phillips Head	Flat Head	10 mm
		Socket Wrench
Driver (+)	Driver (-)
		(for bolts)

8 mm		4 mm Hex
	Spanner	Wrench
Socket Wrench
	(for hinge shaft)	(for bottom
(for bolts)		hinge shaft)

1.Remove 2 screws on the top of the freezer.

Screws

setting up _11