Indoor/outdoor unit installation diagram
Installation space for floor type indoor unit
ffTo minimize the waste of space due to installation, install the indoor unit as shown in below figure.
50cm or more
Protection vinyl
CAUTION
(Be careful of static electricity).
❋❋ After completing the installation, remove the protective filament film on the product.
• Make sure that there are no obstacles (such as curtains etc.) blocking air inlets of the indoor unit.
• Clear space on the right side of the indoor unit for possible filter maintenance in the future.
Piping length for indoor/outdoor unit installation
Noobstaclemore or 1m
Maximum | 6m or | |
less | ||
allowable piping | ||
| ||
elevation 10m |
|
Install
Maximum allowable piping length 20m or less
ffRefer to illustration on the left for maximum allowable piping length and elevation.
ffSince product performance and lifespan may decrease as piping length becomes longer, try to minimize the piping length but make sure it is over 5m.
ffSelect the installation location where you can keep the piping bending to maximum 10 spots.
ffStated cooling performance is based on product with 5m piping.
• One
CAUTION pipe up to 6m of piping elevation. For piping elevation that exceeds 6m, install
6m.
or less |
| 30cm or more | or | |
|
|
| |
| Outdoor unit | 30cm | |
|
| more | |
30cm or | Air guide |
|
|
(Not provided by |
|
| |
more |
|
| |
manufacturer ) | 50cm |
| |
| or | ||
|
| ||
| more | more | |
|
|
| |
| or |
|
|
| 60cm |
|
|
Outdoor |
|
| |
unit leg |
|
| |
| Rubber leg | 20cm or more |
|
|
|
|
Spare space for piping
When air guide needs to be installed to prevent the warm discharge air from disturbing the pedestrian, refer to the illustration on the right side for installation.
38
사우디,인도,나이지리아향 FAC MEMORY 냉방_IBIM_EN_03794A(7).indd 38 |