Chapter 4. Remote control
82
Problem | Possible Solution |
The message | • You cannot use the remote control when you are |
“Disconnecting | configuring Anynet+ or switching to a view mode. |
Anynet+ device ...” | • Use the remote control after the product has |
appears on the screen. | completed Anynet+ configuration or has finished |
| switching to Anynet+. |
|
|
The Anynet+ device | • You cannot use the play function when initial setup is in |
does not play. | progress. |
|
|
The connected device | • Check whether or not the device supports Anynet+ |
is not displayed. | functions. |
| • Check whether or not the HDMI cable is properly |
| connected. |
| • Check whether Anynet+ |
| System menu. |
| • Search Anynet+ devices again. |
| • Anynet+ requires an HDMI connection. Make sure |
| the device is connected to your product with an HDMI |
| cable. |
| • Some HDMI cables may not support Anynet+ functions. |
| • If the connection is terminated because there has |
| been a power failure or the HDMI cable has been |
| disconnected, please repeat the device scan. |
|
|