Crimestopper Security Products manual CS-2000DPII Series

Page 1

CS-2000DPII Series IV

With Data Port Technology

REMOTE CONTROL ALARM SYSTEM

INSTALLATION & OPERATING INSTRUCTIONS

INTRODUCTION

CONGRATULATIONS on your choice of an On-Guard Series Remote Alarm System with Data Port Technology by Crimestopper Security Products Inc. This booklet contains the information necessary for installing, using, and maintaining your alarm system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below.

IMPORTANT INFORMATION: Primary and Optional Features:

-PRIMARY:These are features that must be connected in order for the system to operate properly; i.e. the Siren, L.E.D., 12V Power, Ground, Door pin, Flashing Lights and Override Program Valet Button etc.

-OPTIONAL:These are features to be connected if desired or agreed upon by the installing dealer. These features may also require additional parts and/or labor fees. Consult with your installer beforehand; i.e. Door Locks, Flashing Lights, Starter disable, Hood Trunk trigger, and Auxiliary Remote Outputs etc.

This installation book is designed for the installer or individual with an existing understanding of automotive electrical systems, along with the ability to test and connect wires for proper operation. To ease installation, we suggest that you READ THIS MANUAL before beginning your installation. This book is provided as a GENERAL GUIDLINE and the information contained herein may differ from your vehicle.

TECH SUPPORT

Mon-Fri 8:00 AM-4:30 PM Pacific Time (800) 998-6880

REV. D 1.2007

This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1) This device may not cause interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. Such modification could void the user's authority to operate the equipment.

1

Page 1 Page 2
Image 1
Page 1 Page 2
Contents CS-2000DPII Series Installation Cautions & Warnings Table of ContentsComponent Mounting Control Module MountingGreen Wire Door Trigger WiringViolet Wire + Door Trigger Black Wire System Chassis GroundBrown Wire + Siren Output 3 Amp Max Blue White Wire not Used / no ConnectionWhite Wire 12V Flashing Parking Light Output RED Wire 12V Power Input 15 amp fusePIN Door Lock Plug Optional Power Door Lock WiringRemote Transmitter Programming DiagramOption Programming Programming Options ChartPassive Arming and Chirp Countdown Horn Chirps PulsesIgnition Controlled Locks 60 Sec. Door Open WarningDouble Unlock Pulse Active RE-ARMINGSilent Arming Disarming Chirp Defeat Parking Lights on with DisarmCustom Personal Override Code Carjack FeaturesLock/Unlock or Arm/Disarm with Ignition on Data Port ProtocolAlarm Trigger Reset Alarm TriggeringOperating Instructions Active ArmingProgrammable Silent ARM/DISARM Mode PRE-WARNING Shock Protection & Sensor AdjustmentRemote Panic Protection Trunk Hatch POP Remote AUX. Output 1, OptionalPrior Intrusion Alert Valet Mode Solid LED on DashOpen Zone Alert & Bypass IGNITION-CONTROLLED DoorlocksExport Software Full Time Passive Arming Domestic Software ONE Time Passive ArmingDome Light Illumination Optional Active RE-ARMING Fail Safe ProtectionActive Carjack Carjack ProtectionPassive Carjack FULL-TIME CarjackCS-2000 Dpii Series Vehicle Operation SetupBCM Data Port DiagramOnline Technical Support
Top Page Image Contents