Crimestopper Security Products CS-2000DPII manual Remote Transmitter Programming, Diagram

REMOTE TRANSMITTER PROGRAMMING

1.Turn Ignition ON.

2.Press the Program/Override Button 4 times. After a few second delay, the unit will chirp and flash the lights 4 times.

3.Press button 1 on the remote control you wish to learn. You should get 2 light flashes indicating the unit is waiting for a 2nd code, then press button #1 of a second transmitter or transceiver, the unit will chirp and flash the lights 3 times indicating its waiting for the 3rd code and 4 times for 4th code. If all 4 codes are learned, the unit will automatically exit code-learning mode, otherwise turn key off to exit programming mode.

Note 1: All transmitter codes must be learned at the time of programming. Any transmitters not present will be dropped from system memory. This system will learn a total of 4 transmitters max.

DIAGRAM:

TURN IGN ON

IGN

OFF

PRESS PROGRAM 4 TIMES

OFF

FLASH 2, 3, or 4 X's

PRESS BUTTON #1

ON EACH REMOTE

WAIT FOR 4 FLASHES

IGN

7