OPERATING INSTRUCTIONS
| 2 BUTTON REMOTE TRANSMITTER: | |
ACTIVE ARMING |
|
|
To arm the alarm and lock the doors, press the #1 |
|
|
Button (Lock/Unlock Symbol) on the transmitter. You |
| Flashlight |
will hear a single siren chirp and the lights will flash | LOCK / | |
once. The system will arm, the doors will lock and the | Vehicle #2 | |
starter will be disabled if these optional features are | UNLOCK | |
installed. After a short 5 second delay to allow vehicle |
| |
|
| |
and electronics to settle, the system will be completely |
| AUX. #1 |
armed. The alarm status LED in the vehicle will begin |
| |
flashing. | AUX. #2 | (TRUNK POP) |
|
| |
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 45 seconds. After 45 seconds the siren and lights will stop, but the alarm is still armed to continue to protect the vehicle. If an intruder left the door open,
the unit will cycle a second time before stopping and then continue to protect the other
DISARMING
To disarm the alarm and unlock the doors, press the #1 Button (Lock/Unlock Symbol) on the transmitter. You will hear 2 siren chirps and the lights will flash twice. LED stops flashing. Doors will unlock and dome light will turn on if these optional features are installed.
ALARM TRIGGER RESET
If the armed alarm system is triggered while you are within the range of the remote, pressing the #1 Button will only shut off the siren and lights while leaving the alarm still in an armed status. To disarm the alarm when it is in a triggered status, you must press the #1 Button twice.
12