Crimestopper Security Products CS-2000DPII manual

OPERATING INSTRUCTIONS

DOMESTIC SOFTWARE: ONE TIME PASSIVE ARMING

Passive Arming will work only one time after the ignition is turned off. When you disarm the alarm and re-enter vehicle, the alarm system will not Passive Re-Arm.

EXPORT SOFTWARE: FULL TIME PASSIVE ARMING

The alarm system will always Passive Re-Arm after disarm. The ignition must be turned on to stop Passive Arming.

DOME LIGHT ILLUMINATION ( OPTIONAL )

This feature turns on the vehicles dome light upon disarm for 30 seconds or until the key is inserted and turned on. This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security.

ACTIVE RE-ARMING ( FAIL SAFE PROTECTION )

The Active Re-arming feature allows the system will re-arm itself 30 seconds after being disarmed with the transmitter if a door has not yet been opened. This is handy if the vehicle is accidentally disarmed (via the transmitter in your pocket) without you knowing it. This feature can also be turned off in programming (option #6).

2nd AUX. OUTPUT ( REMOTE AUX. OUTPUT 2 )

To activate the Second auxiliary output press Buttons (1+2) together for (2) seconds. This output can be used to control optional add-on accessories such as a window control module. If installing an add-on on remote start unit, you must use the GRAY AUX#1 channel, not Aux #2.

ARM/DISARM WITH IGNITION ON ( PROGRAM OPTION #15 )

This feature allows the system to be armed or disarmed while the ignition is in the ON position or vehicle is running. The feature is disabled by default and should not be used under normal operating conditions. In some rare instances where an add-on remote start module is used, this option can be enabled to allow the CS-2000DPII alarm to be armed or disarmed when the vehicle is remote started (Ignition ON).