Crimestopper Security Products CS-2000DPII manual Active RE-ARMING, Double Unlock Pulse

Page 10

OPTION PROGRAMMING Cont.

6. ACTIVE RE-ARMING

Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your pocket) without you knowing it.

7. DOUBLE UNLOCK PULSE

The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some Nissan, VW, Toyota, and Lexus vehicles.

8. SILENT ARMING DISARMING ( CHIRP DEFEAT )

With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular Lock/Unlock Button. Flashing parking lights will be the only Arm/Disarm confirmation.

9. PARKING LIGHTS ON WITH DISARM

Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a crowded parking lot or structure. Light will stay on for 30 Sec. or until Ignition is turned on.

10. DISARM WITH AUX. OUTPUT 1 ( TRUNK POP )

Controls whether the system will DISARM when the trunk pop / AUX. feature is used. When the option is turned on, the alarm disarms when opening trunk or using an AUX. device controlled by the Gray output wire.

11. SILENT ARM / DISARM WITH REMOTE BUTTON #2 ( QUICK PRESS )

With this feature, the system can be programmed to Arm and Disarm without a siren chirp using a short press and release of Button #2 on the remote transmitter.

12. DOOR LOCK/UNLOCK PULSE TIME

Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required for 1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.

13. ACTIVE, PASSIVE, or FULL TIME CARJACK PROTECTION

This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1 (Lock) = Active protection. Button 2 (Unlock) = Active and Passive protection. Buttons (1+2) = Full-Time protection. Option number 14 must be enabled to allow Carjack functions to operate.

10

Image 10
Contents CS-2000DPII Series Table of Contents Installation Cautions & WarningsControl Module Mounting Component MountingViolet Wire + Door Trigger WiringGreen Wire Door Trigger Black Wire System Chassis GroundWhite Wire 12V Flashing Parking Light Output Blue White Wire not Used / no ConnectionBrown Wire + Siren Output 3 Amp Max RED Wire 12V Power Input 15 amp fusePower Door Lock Wiring PIN Door Lock Plug OptionalDiagram Remote Transmitter ProgrammingProgramming Options Chart Option ProgrammingIgnition Controlled Locks Horn Chirps PulsesPassive Arming and Chirp Countdown 60 Sec. Door Open WarningSilent Arming Disarming Chirp Defeat Active RE-ARMINGDouble Unlock Pulse Parking Lights on with DisarmLock/Unlock or Arm/Disarm with Ignition on Carjack FeaturesCustom Personal Override Code Data Port ProtocolOperating Instructions Alarm TriggeringAlarm Trigger Reset Active ArmingRemote Panic Protection PRE-WARNING Shock Protection & Sensor AdjustmentProgrammable Silent ARM/DISARM Mode Trunk Hatch POP Remote AUX. Output 1, OptionalOpen Zone Alert & Bypass Valet Mode Solid LED on DashPrior Intrusion Alert IGNITION-CONTROLLED DoorlocksDome Light Illumination Optional Domestic Software ONE Time Passive ArmingExport Software Full Time Passive Arming Active RE-ARMING Fail Safe ProtectionPassive Carjack Carjack ProtectionActive Carjack FULL-TIME CarjackCS-2000 Dpii Series Setup Vehicle OperationData Port Diagram BCMOnline Technical Support