Crimestopper Security Products CS-2000DPII manual Custom Personal Override Code, Carjack Features

Page 11

OPTION PROGRAMMING Cont.

14. CARJACK FEATURES

This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with this option.

15. Lock/Unlock or Arm/Disarm with Ignition ON

This option allows you Arm and Disarm the system with the Ignition ON. This is used when there is a remote starter added to the system. The default is lock/unlock without arm and disarm while the ignition on.

16. Data Port Protocol:

This option controls the Data Port Protocol for 1-Way (OFA modules) or 2-Way (SL modules). The default is set for 2-Way Protocol. This option has no effect on conventional wiring of Bypass modules.

CUSTOM PERSONAL OVERRIDE CODE

Custom override allows the user to set a specific number of button presses (2-15) required to perform an emergency override/disarm of the alarm system. This increases the level of security of the system, but you MUST MEMORIZE how many button presses you have changed your system to use or the unit will not disarm in an emergency.

1.Enter programming mode. (See step #1 on page 8)

2.Press program button three times to go to option #3 “Passive Locks/Custom Override”.

3.Press both Buttons (1+2) on the remote transmitter (3 chirps).

4.Press and release the program again the number of times you desire in order to perform emergency disarm on this alarm system. Press the program button 2-15 times only. You need to wait for the siren to chirp the same number of times you pressed the program button to confirm.

To test feature: Trip the alarm system, turn key ON, press the program/valet button 2-15 times as programmed above then continue to HOLD DOWN valet button on the LAST PRESS for 5 seconds. Alarm should disarm. If system does not disarm, then disarm with the remote transmitter and try again. If system still does not disarm or you have forgotten your custom code, then you must use your remote control to disarm the system

CAUTIONARY NOTE!

If you set up this feature and forget your special code, there is no way to disarm the system other than the remote control.

11

Image 11
Contents CS-2000DPII Series Installation Cautions & Warnings Table of ContentsComponent Mounting Control Module MountingBlack Wire System Chassis Ground WiringGreen Wire Door Trigger Violet Wire + Door TriggerRED Wire 12V Power Input 15 amp fuse Blue White Wire not Used / no ConnectionBrown Wire + Siren Output 3 Amp Max White Wire 12V Flashing Parking Light OutputPIN Door Lock Plug Optional Power Door Lock WiringRemote Transmitter Programming DiagramOption Programming Programming Options Chart60 Sec. Door Open Warning Horn Chirps PulsesPassive Arming and Chirp Countdown Ignition Controlled LocksParking Lights on with Disarm Active RE-ARMINGDouble Unlock Pulse Silent Arming Disarming Chirp DefeatData Port Protocol Carjack FeaturesCustom Personal Override Code Lock/Unlock or Arm/Disarm with Ignition onActive Arming Alarm TriggeringAlarm Trigger Reset Operating InstructionsTrunk Hatch POP Remote AUX. Output 1, Optional PRE-WARNING Shock Protection & Sensor AdjustmentProgrammable Silent ARM/DISARM Mode Remote Panic ProtectionIGNITION-CONTROLLED Doorlocks Valet Mode Solid LED on DashPrior Intrusion Alert Open Zone Alert & BypassActive RE-ARMING Fail Safe Protection Domestic Software ONE Time Passive ArmingExport Software Full Time Passive Arming Dome Light Illumination OptionalFULL-TIME Carjack Carjack ProtectionActive Carjack Passive CarjackCS-2000 Dpii Series Vehicle Operation SetupBCM Data Port DiagramOnline Technical Support