Crimestopper Security Products CS-2000DPII Valet Mode Solid LED on Dash, Prior Intrusion Alert

Page 14

OPERATING INSTRUCTIONS

VALET MODE ( Solid LED on Dash )

To disable the Alarm system for vehicle service or otherwise, turn the ignition on and press the override/program button 4-5 seconds until the dash LED turns on solid and you hear (1) siren chirp. Repeat the process to exit VALET mode and the system will chirp (2) times and the LED will turn off. Lock Unlock and AUX features will still operate in when in VALET mode.

PRIOR INTRUSION ALERT

If the system was tripped in your absence, the dash LED will be flashing rapidly. When the system is disarmed you will hear 1 chirp, then 2 additional chirps/flashes. Carefully inspect your vehicle.

OPEN ZONE ALERT & BYPASS

If the system detects a faulty or open zone (Door left open) when the system is ACTIVELY ARMED, the siren will chirp 5 times along with 5 light flashes. The faulty zone will be automatically bypassed.

IGNITION-CONTROLLED DOORLOCKS

If this feature is enabled, the doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off. This feature can be programmed on, off, or to lock the doors only. Doors will not lock if they are open to prevent locking the keys in.

PASSIVE ARMING, PASSIVE LOCK MODES and PASSIVE CHIRP COUNTDOWN

If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last door has been closed. The LED will begin flashing rapidly while counting down. If a door is reopened, the system will wait for the door or zone to close before arming. The unit will flash the lights once. Doors will lock if the “Passive Locking” feature is enabled. Passive Arm/Lock may qualify for insurance discounts-check with your agent or proprietor. When the Unit is programmed for Passive Chirp Countdown, the siren will chirp during passive countdown, as an audible warning that arming will occur. The siren will chirp every 2 seconds as soon as the last door is closed until the system arms 30 seconds later.

NOTE: There are 2 Versions of software, one for Domestic and one Export markets. See next page.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents CS-2000DPII Series Table of Contents Installation Cautions & WarningsControl Module Mounting Component MountingViolet Wire + Door Trigger WiringGreen Wire Door Trigger Black Wire System Chassis GroundWhite Wire 12V Flashing Parking Light Output Blue White Wire not Used / no ConnectionBrown Wire + Siren Output 3 Amp Max RED Wire 12V Power Input 15 amp fusePower Door Lock Wiring PIN Door Lock Plug OptionalDiagram Remote Transmitter ProgrammingProgramming Options Chart Option ProgrammingIgnition Controlled Locks Horn Chirps PulsesPassive Arming and Chirp Countdown 60 Sec. Door Open WarningSilent Arming Disarming Chirp Defeat Active RE-ARMINGDouble Unlock Pulse Parking Lights on with DisarmLock/Unlock or Arm/Disarm with Ignition on Carjack FeaturesCustom Personal Override Code Data Port ProtocolOperating Instructions Alarm TriggeringAlarm Trigger Reset Active ArmingRemote Panic Protection PRE-WARNING Shock Protection & Sensor AdjustmentProgrammable Silent ARM/DISARM Mode Trunk Hatch POP Remote AUX. Output 1, OptionalOpen Zone Alert & Bypass Valet Mode Solid LED on DashPrior Intrusion Alert IGNITION-CONTROLLED DoorlocksDome Light Illumination Optional Domestic Software ONE Time Passive ArmingExport Software Full Time Passive Arming Active RE-ARMING Fail Safe ProtectionPassive Carjack Carjack ProtectionActive Carjack FULL-TIME CarjackCS-2000 Dpii Series Setup Vehicle OperationData Port Diagram BCMOnline Technical Support
Top Page Image Contents