Crimestopper Security Products CS-2002DPII manual LED / Valet POD Operation & Mounting

Page 18

CARJACK PROTECTION FEATURES

FULL-TIME CARJACK

ONLY USE THIS MODE WHEN THERE IS AN EXTREME TREAT OF A CARJACK WITH YOUR VEHICLE. Full-time Carjack protection must be enabled before use through Alarm programming options (13) & (14). See page 10. EVERY TIME the Ignition is turned ON or a door is opened and closed with the Ignition ON, a Carjack countdown sequence will be initiated. 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into a full system activation with siren/flashing light pulses for 5 min. You must reset the unit every time the IGNITION is turned on or a door is opened and closed when the ignition is on. To reset Ignition must be ON, doors must be closed, then press override/program button (3) times.

NOTE: When FULL TIME CARJACK is in effect, it must be reset every time the key is turned on, Door is opened, before entering VALET mode, and before Programming options or transmitters! It is always in effect each time the Ignition is turned on and/or a door is opened with Ignition on! If power becomes disconnected, then re-connected the Carjack Full-time carjack trigger will be active. Press the override button 3 times with the Key on the doors closed to reset.

LED / VALET POD OPERATION & MOUNTING

LED / VALET BUTTON POD:

LED POD

SYSTEM

LED

VALET/PROGRAM

BUTTON

LED / VALET BUTTON POD MOUNTING:

UNDER

DASH

IN DASH

 

Use

 

OR

"L" Bracket

 

18

 

 

Image 18
Contents CS-2002DPII Table of Contents Installation Cautions & WarningsViolet Wire + Positive Door Trigger WiringGreen Wire Negative Door Trigger Control Module & Component MountingBlack Wire System Chassis Ground Yellow Wire Ignition Switched on and Start +12 VoltsBrown Wire + Siren Output 3 Amp Max Power Door Lock Wiring PIN Plug White Alarm Status LED IndicatorPIN Sensor PLUG/HARNESS Blue Negative Trigger Doorlock Wiring Separate DRIVER’S Door Unlock Wiring Negative Trigger Door LocksTransmitter Programming Programming Options Chart Option ProgrammingHorn Chirps / Pulses Passive Arming / Chirp CountdownDouble Unlock Pulse Programmable Option Reset Custom Personal Override CodeOperating Instructions Active Arming Programmable Silent ARM/DISARM Mode Chirp Defeat PRE-WARNING Shock Protection & Sensor Adjustment Selective Silent ARM/DISARM Through Remote Control TRUNK/HATCH POP Remote AUX. Output 1, OptionalValet Mode Carjack Protection Features Active RE-ARMING FAIL-SAFE ProtectionLED / Valet POD Operation & Mounting LED / Valet Button PODLED / Valet Button POD Mounting Under Dash CS-2002DPII Data Port Diagram BCM