Crimestopper Security Products CS-2002DPII manual Brown Wire + Siren Output 3 Amp Max

WIRING

BLUE/WHITE WIRE: (-) PASSENGER(S) DOOR UNLOCK OUTPUT (Optional, requires relay)

Connects to unlock circuit for passenger door(s) when using separate driver’s door unlock option. See SEPARATE DRIVER’S DOOR UNLOCK WIRING on Page 8 for some configuration options.

BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)

Connect to RED siren wire from the Siren in the engine compartment.

WHITE WIRE: PARKING LIGHT OUTPUT: +12V or (-) Negative Ground (Jumper Selectable)

Connect to switched +12V parking light wire at back of light switch. If this is not possible, connect directly to one of the parking lights at the front of the vehicle. If your vehicle requires a (-) Negative Ground signal to activate the parking lights, then you have to move the jumper located on the circuit board inside the unit. For European vehicles with separate right and left circuits, use a dual relay or 2 diodes to separate the output signal. The DEFAULT output is Positive. Carefully snap open the control module and see illustration below.

CS-2002DP IV Parking light output: The jumper plug inside the control module determines the unit's (+) or (-) Parking Light output. Use the jumper pin to select Positive or Negative Polarity Output. (*Default = Positive)

CS-2002DP IV MODULE

TOP VIEW OF P4 JUMPER

JUMPER PLUG

NEGATIVE LIGHTS

+12V POSITIVE LIGHTS (DEFAULT)

JUMPER

PINS

SIDE VIEW

5