Crimestopper Security Products CS-2002DPII manual

CS-2002DPII

With Data Port Technology

REMOTE CONTROL ALARM SYSTEM

INSTALLATION & OPERATING INSTRUCTIONS

INTRODUCTION

CONGRATULATIONS on your choice of an “On-Guard” Remote Alarm System with DP Technology by Crimestopper Security Products Inc. This booklet contains the information necessary for installing, using, and maintaining your alarm system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below.

*IMPORTANT INFORMATION: Primary and Optional Features:

-PRIMARY:These are features that must be connected in order for the system to operate properly; i.e. the Siren, +12V Power, Ground, Door pin, Flashing lights, LED/Valet Pod etc.

-OPTIONAL:These are features to be connected if desired or agreed upon by the installing dealer. These features may also require additional parts and/or labor fees. Consult with your installer beforehand; i.e. Door Locks, Starter disable, Hood/Trunk trigger, and Auxiliary Remote Outputs etc.

This installation book is designed for the installer or individual with an existing understanding of automotive electrical systems, along with the ability to test and connect wires for proper operation. To ease installation, we suggest that you READ THIS MANUAL before beginning your installation. This book is provided as a GENERAL GUIDLINE and the information contained herein may differ from your vehicle.

TECH SUPPORT

Mon-Fri 8:00 AM-4:30 PM Pacific Time (800) 998-6880

REV. D 1.2007

This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1) This device may not cause interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused

by unauthorized modification to this equipment. Such modification

1

could void the user's authority to operate the equipment.