Mount Installation

Installation Instructions

CM2

The CM2 has been designed to be mounted into a cabinet or similar type of furnishing.

The following installation instructions assume a suitable structure and surface exists prior to installation.

WARNING: IMPROPER INSTALLATION CAN LEAD TO LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installers responsibility to make certain the structure to which the lift is being mounted is capable of supporting 4 times the weight of the lift and all attached equipment.

IMPORTANT ! : The finished furniture with display on and mount fully raised must be able to be placed at a 10° angle front and back without tipping.

To install the CM2:

1.If the display is installed and cables routed, disconnect wires and cables from display, uninstall top shelf and display.

2.Remove mount from wooden supports used during mount setup and configuration.

WARNING: MOUNT WEIGHS IN EXCESS OF 40LBS! Always use two people and proper lifting techniques when installing or positioning mount.

3.Determine base position within furnishing framework.

4.Position mount until base is properly positioned and side mounting brackets are in line with vertical supports. (See figure 23)

5.Loosen four screws securing side mounting brackets to mount and adjust side mounting brackets until properly positioned against vertical mounting surface.

(See figure 24)

6.Tighten four screws to hold position of side mounting brackets. (See figure 24)

Figure 23

7.Mark eight base mounting hole locations. (See figure 24)

8.Drill pilot holes at marked locations.

9.Mark four side bracket mounting hole locations. (See figure 41)

10.Drill four pilot holes at marked locations.

11.Secure mount base to mounting surface using eight screws. (See figure 24)

12.Secure mount to vertical mounting surface using four screws. (See figure 24)

X4	9
	X4 10
12
	8
11	X8
11
	7
	X8

Figure 24

13.Install display following the procedures outlined in Install Display section on page 7.