Installation Instructions | CM2 |
15.Align studs in faceplate with appropriate holes in faceplate mounting bracket and hang faceplate on bracket with studs.
16.Secure faceplate to faceplate mounting bracket using two locknuts. (See figure 7)
16 | x2 |
Figure 7
Display Installation
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY CAN LEAD TO SERIOUS PERSONAL INJURY OR AMAGE TO EQUIPMENT! It is the installers responsability to ensure the total amount of weight placed on the mount does not exceed 190lbs (86.18 kg) the maximum capaity of the CM2.
1.If lift was raised during faceplate configuration, lower the lift until it stops using the remote control.
WARNING: PINCH HAZARD! FINGERS OR HANDS BETWEEN MOVING PARTS CAN LEAD TO SEVERE PERSONAL INJURY! Keep fingers and hands away from mount when operating.
1 |
1 |
Figure 8
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Displays can weigh in excess of 40 lbs (18.1kg). ALWAYS use two people and proper lifting techniques when installing display.
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make sure mounting buttons on display are properly seated in mounting holes in faceplate.
To install display:
1.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in faceplate. (See figure 9) and (See figure 10)
2.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes and "click lock" mechanism has engaged. (See figure 9) and (See figure 10)
1 |
Figure 9:
Remove pin | 1 | |
and nuts and | ||
| ||
move to lower holes. |
| |
| 2 | |
| A padlock or bolt may | |
| be placed through latch | |
| holes |
Figure 10
7