Heatiator ECO-WINS18 Listing and Code Approvals, Appliance Certification, Mobile Home Approved

Page 6

1 Listing and Code Approvals

A. Appliance Certification

Model:

ECO-WINS18

Laboratory:

Intertek

Report No:

100398890PRT-001

Type:

Solid Fuel Type, Listed Room Heater

Standard:

UL1482 and ULC S628-93 and

 

(UM) 84-HUD, Mobile Home

 

Approved.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the UL1482, (UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S628- 93 and CAN/CSA-B365 Installation Codes in Canada.

D. BTU & Efficiency Specifications

EPA Certified:

2.6 grams per hour

Efficiency:

88%

BTU Output:

10,900 to 22,600 / hr

Heating Capacity:

1,130 to 2,060 sq ft depend-

 

ing on climate zone

Vent Size:

6 inches

Firebox Size:

2.0 cubic feet

Max Wood Length:

18 inches

Fuel:

Cord Wood

Shipping Weight:

337 lbs

The Heatilatro ECO-WINS18 meets the U.S. Environmental Protection Agency’s 1990 particulate emission standards.

Intertek Testing Laboratory is a National Recognized Test Lab (NRTL) approved by OSHA.

B.Mobile Home Approved

•This appliance is approved for mobile home installa- tions when not installed in a sleeping room and when an outside combustion air inlet is provided.

•The structural integrity of the mobile home floor, ceil- ing, and walls must be maintained.

•The appliance must be properly grounded to the frame of the mobile home with #8 copper ground wire, and use only listed double-wall connector pipe.

•Outside Air Kit, part OAK-ACC must be installed in a mobile home installation.

C.Glass Specifications

This stove is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire - If appliance or chimney connector glows, you are overfiring.

Any such action that may cause a fire hazard.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

ECO-CHOICE is a registered trademark of Hearth & Home Technologies.

6

Heatilator • ECO-WINS18 • 7065-132B • August 29 2011

Page 5 Page 7
Image 6
Page 5 Page 7
Contents If the information in these instruc Fire may result causing propertyModel Tions is not followed exactly, aHeatilator ECO-WINS18 7065-132B August 29 Mfg Date Table of Contents Heatilator ECO-CHOICE Warranty Warranty Exclusions Listing and Code Approvals BTU & Efficiency SpecificationsGlass Specifications Appliance CertificationOperating Instructions Your Wood ApplianceCombustible/Non-combustible Materials Fire SafetyOverfiring Seasoned WoodKindling or First Stage Burning ProcessSecond Stage Final StageBurn Rate Air Control Burn Rates and Operating EfficiencyCorrect Baffle & Blanket Placement Fire RiskBuilding a Fire Wood Fuel & Storage Hardwood vs SoftwoodBlower Control Box & Snap Disc Operating Instructions Blower Operating InstructionsFrequently Asked Questions Clear SpaceOpacity Smoke Quick Start Guide Your specific modelDisposal of Ashes Maintenance and ServiceChimney and Chimney Connector Inspection/Cleaning Appliance Inspection RoutineGlass Cleaning Inspect Firebrick & Replacement InstructionsFrequency As desired Quick Reference Maintenance Guide MonthlyTroubleshooting Guide Start Fire Problems Possible Cause SolutionSnap Disc Replacement Service Parts ReplacementGlass Replacement Snap Disc Replacement Contd Wiring DiagramBlower Replacement Shock RiskDoor Handle Assembly Baffle & Ceramic Blanket RemovalTube Channel Assembly Replacement Design and Installation Considerations Getting StartedDraft Negative Pressure Locating Your Appliance & Chimney Chimney Termination RequirementsRule Tools And Supplies Needed Inspect Appliance and ComponentsDimensions and Clearances Appliance DimensionsSurround Sizes SideWall Mantel ClearanceThermal Protection Required Ember Protection OnlyThermal Conductivity k value Conversion ProcedureAlternate Floor Protection Calculation Thermal Resistance R valueInspections Chimney SystemsVenting Systems Larger ChimneysMasonry Chimney Cont’d Metal Heat Circulating Masonry Prefabricated Metal ChimneySecuring Chimney Components Altering the FireplaceFactory-Built Sold Fuel Fireplace Ovalizing Round Stainless Steel Liners Chimney Height / Rise and RunAppliance Set-up Outside Air Kit InstallationOutside Air Installation Instructions Outside Air Kit OptionOptional Offset Adapter Installation Securing Stove Pipe/Liner to Flue CollarStandard Surround & Trim Kit Installation Securing Appliance to Stove Pipe/LinerMobile Home Installation ECO-WINS18 Reference MaterialsStocked Service Parts#6 Bay Side/Blower Assembly At Depot#12 Door Assembly #13 Brick Assembly#24 Burn Rate Control Assembly Fastener PacksService And Maintenance Log Date of Service Performed By Description of ServiceContact Information For Consumer Care

ECO-WINS18 specifications

The Heatiator ECO-WINS18 is a cutting-edge heating solution designed to elevate warmth and comfort in residential and commercial spaces. This innovative unit embodies modern technology, efficiency, and user-centric design, making it a noteworthy choice for anyone in the market for a reliable heating system.

One of the standout features of the ECO-WINS18 is its advanced energy efficiency. This unit boasts a high efficiency rating, significantly reducing energy consumption while delivering powerful heating capabilities. This translates to lower energy bills and a reduced carbon footprint, aligning with growing environmental consciousness among consumers.

The ECO-WINS18 employs a dual heating system that includes both convection and radiant heat technologies. This hybrid approach ensures rapid heat distribution throughout the room, providing consistent warmth while eliminating cold spots. The convection component circulates warm air, while the radiant heat warms objects and surfaces directly, creating a cozy atmosphere.

User convenience is a priority in the design of the ECO-WINS18. It comes equipped with a user-friendly digital thermostat that allows precise temperature control with ease. Additionally, the unit features programmable settings, enabling users to customize heating schedules to suit their lifestyle. This not only enhances comfort but also promotes energy savings.

Safety is a critical consideration in any heating appliance, and the ECO-WINS18 excels in this area as well. It includes multiple safety features such as overheat protection and a tip-over switch that automatically shuts the unit down if it is accidentally knocked over. This ensures peace of mind for users, especially in homes with children and pets.

The sleek and modern design of the ECO-WINS18 allows it to blend seamlessly with various decors, making it an aesthetic addition to any room. The compact size of the unit makes it easy to install, and it can be used as a standalone piece or integrated with existing heating systems.

In summary, the Heatiator ECO-WINS18 stands out for its superior energy efficiency, dual heating technology, user-friendly controls, and safety features. Its modern design not only enhances interior aesthetics but also offers practical functionality. For those seeking an effective and reliable heating solution, the ECO-WINS18 is a wise investment that promises comfort and efficiency for years to come.
Top Page Image Contents