Heath Zenith 6107 manual Operations, Using the Light Control, Auto

Page 11

OPERATIONS

Using the Light Control

One of three functions can be selected by using the three-position switch on the 6107:

Off: When you want the light off all the time.

The light will not be switched on by either switch. Put the control in this position when changing light bulbs.

Auto:

When you want the light to come on and turn off auto- matically with motion or turn on with remote switch.

The control will switch the light on when motion is detected. If no further motion is detected, the light will turn off after the pre-set time period. To turn the light on again, move in the detection zone. Flipping the remote switch up or down will turn the light on for the pre-set time period.

On: When you want the light on all the time.

In this position, the light will remain on all the time, daytime and night. Flipping the remote switch will not affect the light. The Photo shut-off is also inactive.

595-4514-16-11-

Image 11
Contents Motion Sensing Way Wall Switch Installation ONE 6107 Switch in Circuit Connect Jumper at the Remote Switch Add Jumper At Remote 3-Way SwitchTurn the power off at the circuit breaker Replace Other SwitchTest For Correct Common Wire Connection Turn power off before rewiring Troubleshooting Wiring ConnectionsInstallations, con- nect the wall switch as shown here Special InstallationsPhoto Sensitivity AdjustmentM E Install Wall Cover PlateTime Control Operations Using the Light ControlOff When you want the light off all the time On When you want the light on all the timeTroubleshooting Auto mode, light turns on in daylight Technical ServiceNo Service Parts Available for this Product Auto mode, light does not stay onSpecifications Five Year Limited Warranty El Interruptor Tridireccional de pared y Dectector de Instalacion 18-595-4514-16 Conecte el Cable Conector en el Interruptor a Control Remoto Instale el Detector de Movimiento en el otro inte- rruptor Prueba para la conexión correcta de un cable común Apague la energia antes de reconectar Conexiones de cableado para análisis de averíasSe muestra aquí Instalaciones EspecialesSensibilidad de Foto AjusteInstale la Tapa de Pared Control del TiempoOn Cuando quiere que la luz esté siempre prendida FuncionamientoCómo usar el Control de Luz Off Cuando quiere que la luz esté siempre apagadaEl interruptor a control remoto no funciona Investigacion DE AveriasLa luz no se prende La luz no se apagaLa luz se prende durante el día cuando está en auto- mático Servicio TécnicoLa luz no se prende cuando está en automático La luz no se queda prendida cuando está en automáticoHasta 400 Vatios Máximo Estabilizador de arranque rápido EspecificacionesGarantía Limitada a 5 Años 595-4514-16-31 Purchase Information Información de la compra