Heath Zenith 6107 manual Troubleshooting Wiring Connections, Turn power off before rewiring

Page 7

INSTALLATION

Mount the 6107 into the junction box with the two junction box screws.

Turn the circuit breaker back on.

Preset the controls: Time to minutes, Photo Adjustment fully clockwise. Cover the lens with masking tape.

With the motion sensor in the “ON” position, turn the remote switch on and off several times. Go to step 1, 2, or 3, depending on results.

Troubleshooting Wiring Connections

* Turn power off before rewiring!

1.

2.

If light does not

turn on:

If light turns on in only one position of remote switch:

Exchange*

Control’s

Red Black

wires.

Exchange*

Control’s

Red Brown

wires.

Test again. Go

to 2 or 3.

Test again. Go

to 1 or 3.

3.

If light turns

on with remote switch in either position:

Set sensor to “AUTO”. Wait for the unit to warm up (up to 1 min.). If the remote switch can turn the lights on, it’s OK. Otherwise:

Exchange* Control’s

Black Brown wires. Remove the tape. Go to the next page.

595-4514-16

- -

Image 7
Contents Motion Sensing Way Wall Switch Installation ONE 6107 Switch in Circuit Connect Jumper at the Remote Switch Add Jumper At Remote 3-Way SwitchTurn the power off at the circuit breaker Replace Other SwitchTest For Correct Common Wire Connection Turn power off before rewiring Troubleshooting Wiring ConnectionsInstallations, con- nect the wall switch as shown here Special InstallationsPhoto Sensitivity AdjustmentTime Control Install Wall Cover PlateM E Operations Using the Light ControlOff When you want the light off all the time On When you want the light on all the timeTroubleshooting Auto mode, light turns on in daylight Technical ServiceNo Service Parts Available for this Product Auto mode, light does not stay onSpecifications Five Year Limited Warranty El Interruptor Tridireccional de pared y Dectector de Instalacion 18-595-4514-16 Conecte el Cable Conector en el Interruptor a Control Remoto Instale el Detector de Movimiento en el otro inte- rruptor Prueba para la conexión correcta de un cable común Apague la energia antes de reconectar Conexiones de cableado para análisis de averíasSe muestra aquí Instalaciones EspecialesSensibilidad de Foto AjusteInstale la Tapa de Pared Control del TiempoOn Cuando quiere que la luz esté siempre prendida FuncionamientoCómo usar el Control de Luz Off Cuando quiere que la luz esté siempre apagadaEl interruptor a control remoto no funciona Investigacion DE AveriasLa luz no se prende La luz no se apagaLa luz se prende durante el día cuando está en auto- mático Servicio TécnicoLa luz no se prende cuando está en automático La luz no se queda prendida cuando está en automáticoHasta 400 Vatios Máximo Estabilizador de arranque rápido EspecificacionesGarantía Limitada a 5 Años 595-4514-16-31 Purchase Information Información de la compra