Heath Zenith 6107 manual Adjustment, Photo Sensitivity

ADJUSTMENT

Photo Sensitivity

	ON
OFF	AUTO
	5 Seconds

Press in with screwdriver. Swing out cover to remove.

Any Light Level Dark

+

5 10

115

Test20

T I M EL I G H T

20 Minutes

The sensor can be prevented from turning on lights when there is already enough light in the room. Use a small screwdriver to set the light level using this diagram as a guide. In the fully clockwise position, the sensor turns on lights even in full daylight. In the fully counter-clockwise position, the sensor only turns on lights when the surrounding light level is very low.

❐With the switch in the AUTO position and the light at the desired level for the lights to turn on, put the LIGHT control to the minimum dark (fully counter-clockwise) position. Wait for the lights to turn off.

❐Move your hand in front of the sensor. While moving your hand in front of the sensor, slowly turn the LIGHT adjustment clockwise until the lights controlled by the sensor come on.

595-4514-16 - -