Heath Zenith manual ONE 6107 Switch in Circuit

Page 3

INSTALLATION

See pages 4 through 6 for detailed instructions for installing and wiring the 6107 Wall Switch.

ONE 6107 SWITCH IN CIRCUIT

WHITE WHITE WHITE

FROM

POWER BLACK *COMMON*COMMON

SOURCE

RED

(In Wall)

BLACK	BLACK

6107 SWITCH 1ST IN CIRCUIT

WHITE	WHITE	WHITE
FROM		ADD JUMPER WIRE
POWER		ADD JUMPER WIRE
POWER
SOURCE		*COMMON
		*COMMON
BLACK BLACK	BROWN	RED
		(In Wall)
OFF AUTO	ON		BLACK
	RED	BLACK	BLACK
	RED	BLACK
6107	(From 6107)	EXISTING
6107		EXISTING

3-WAY SWITCH

6107 SWITCH 2ND IN CIRCUIT

WHITE

WHITE

WHITE

FROM	ADD JUMPER WIRE
POWER
SOURCE		*COMMON
BLACK		RED	BROWN		BLACK
		(In Wall)
			OFF AUTO	ON	BLACK
		BLACK	RED		BLACK
		BLACK	RED
		EXISTING	(From 6107)		6107
		EXISTING			6107

3-WAY SWITCH

*COMMON-Used for illustrative Purposes Only. Check Your Switch. The common may be in a different loca- tion, depending on the brand of your switch.

RED is used to represent the second wire between two standard three-way switches. This may not be the color used in all installation. If you are not sure about your wiring, call an electrician for installation help. There is also a RED wire on the 6107 switch. Check the instructions above closely and do not confuse the two.

595-4514-16

- -

Image 3

Contents Motion Sensing Way Wall Switch Installation ONE 6107 Switch in Circuit Connect Jumper at the Remote Switch Add Jumper At Remote 3-Way SwitchTurn the power off at the circuit breaker Replace Other SwitchTest For Correct Common Wire Connection Turn power off before rewiring Troubleshooting Wiring ConnectionsInstallations, con- nect the wall switch as shown here Special InstallationsPhoto Sensitivity AdjustmentInstall Wall Cover Plate Time ControlM E Operations Using the Light ControlOff When you want the light off all the time On When you want the light on all the timeTroubleshooting Auto mode, light turns on in daylight Technical ServiceNo Service Parts Available for this Product Auto mode, light does not stay onSpecifications Five Year Limited Warranty El Interruptor Tridireccional de pared y Dectector de Instalacion 18-595-4514-16 Conecte el Cable Conector en el Interruptor a Control Remoto Instale el Detector de Movimiento en el otro inte- rruptor Prueba para la conexión correcta de un cable común Apague la energia antes de reconectar Conexiones de cableado para análisis de averíasSe muestra aquí Instalaciones EspecialesSensibilidad de Foto AjusteInstale la Tapa de Pared Control del TiempoOn Cuando quiere que la luz esté siempre prendida FuncionamientoCómo usar el Control de Luz Off Cuando quiere que la luz esté siempre apagadaEl interruptor a control remoto no funciona Investigacion DE AveriasLa luz no se prende La luz no se apagaLa luz se prende durante el día cuando está en auto- mático Servicio TécnicoLa luz no se prende cuando está en automático La luz no se queda prendida cuando está en automáticoHasta 400 Vatios Máximo Estabilizador de arranque rápido EspecificacionesGarantía Limitada a 5 Años 595-4514-16-31 Purchase Information Información de la compra