Heath Zenith 6107 manual Technical Service, Auto mode, light does not stay on

Page 13

TROUBLESHOOTING

In the Auto mode, light does not stay on:

•Motion is needed to keep the light on.

•Time control is adjusted for too little time. Turn the Time control clockwise. Note: In the minimum time position, fluorescent lights may not have enough time to turn on.

In the Auto mode, light turns on in daylight:

•Photo adjustment not set properly. Turn the Photo control counter- clockwise towards the DARK position.

Technical Service

Please call 1-800-858-8501 (English speaking only) for

assistance before returning product to store.

If you experience a problem, follow this guide.You may also want to visit our Web site at: www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501(English speaking only), 7:30 AM to 4:30 PM CST (M-F). You may also write* to:

HeathCo LLC

P.O. Box 90004, Bowling Green, KY 42102-9004 ATTN: Technical Service

*If contacting Technical Service, please have the following infor- mation available: Model Number, Date of Purchase, and Place of Purchase.

No Service Parts Available for this Product

595-4514-16-13-

Image 13

Contents Motion Sensing Way Wall Switch Installation ONE 6107 Switch in Circuit Connect Jumper at the Remote Switch Add Jumper At Remote 3-Way SwitchTurn the power off at the circuit breaker Replace Other SwitchTest For Correct Common Wire Connection Turn power off before rewiring Troubleshooting Wiring ConnectionsInstallations, con- nect the wall switch as shown here Special InstallationsPhoto Sensitivity AdjustmentTime Control Install Wall Cover PlateM E Off When you want the light off all the time Using the Light ControlOn When you want the light on all the time OperationsTroubleshooting No Service Parts Available for this Product Technical ServiceAuto mode, light does not stay on Auto mode, light turns on in daylightSpecifications Five Year Limited Warranty El Interruptor Tridireccional de pared y Dectector de Instalacion 18-595-4514-16 Conecte el Cable Conector en el Interruptor a Control Remoto Instale el Detector de Movimiento en el otro inte- rruptor Prueba para la conexión correcta de un cable común Apague la energia antes de reconectar Conexiones de cableado para análisis de averíasSe muestra aquí Instalaciones EspecialesSensibilidad de Foto AjusteInstale la Tapa de Pared Control del TiempoCómo usar el Control de Luz FuncionamientoOff Cuando quiere que la luz esté siempre apagada On Cuando quiere que la luz esté siempre prendidaLa luz no se prende Investigacion DE AveriasLa luz no se apaga El interruptor a control remoto no funcionaLa luz no se prende cuando está en automático Servicio TécnicoLa luz no se queda prendida cuando está en automático La luz se prende durante el día cuando está en auto- máticoHasta 400 Vatios Máximo Estabilizador de arranque rápido EspecificacionesGarantía Limitada a 5 Años 595-4514-16-31 Purchase Information Información de la compra