Heath Zenith 6107 manual Specifications

Page 14

SPECIFICATIONS

This product is to be installed indoors only.

Electrical Input

120V, 60 Hz.

Fluorescent* Load

(2) 30 Watt minimum,

 

Up to 400 Watts Maximum Rapid Start Ballast

Motor Load

Up to 1/8 HP Maximum

Incandescent

Up to 500 Watts at 120VAC

On-Time

Adjustable approximately 5 sec. to 20 min.

Photocell Sensor

From full daylight to less than 1 FC.

Coverage

up to 15 ft. (4.6 m) at 150°,

 

up to 30 ft. (9.1 m) in front of the sensor

Specification subject to change without notice.

*Designed for use with standard 3 ft./30 watt and 4 ft./40 watt rapid-start fluorescent tubes. Not designed for use with compact fluorescent bulbs.

Minimum of two tubes required. Note: May not be used to operate electronic or magnetic ballasts.

HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in previously sold products.

-14-595-4514-16

Image 14
Contents Motion Sensing Way Wall Switch Installation ONE 6107 Switch in Circuit Add Jumper At Remote 3-Way Switch Connect Jumper at the Remote SwitchReplace Other Switch Turn the power off at the circuit breakerTest For Correct Common Wire Connection Troubleshooting Wiring Connections Turn power off before rewiringSpecial Installations Installations, con- nect the wall switch as shown hereAdjustment Photo SensitivityM E Install Wall Cover PlateTime Control On When you want the light on all the time Using the Light ControlOff When you want the light off all the time OperationsTroubleshooting Auto mode, light does not stay on Technical ServiceNo Service Parts Available for this Product Auto mode, light turns on in daylightSpecifications Five Year Limited Warranty El Interruptor Tridireccional de pared y Dectector de Instalacion 18-595-4514-16 Conecte el Cable Conector en el Interruptor a Control Remoto Instale el Detector de Movimiento en el otro inte- rruptor Prueba para la conexión correcta de un cable común Conexiones de cableado para análisis de averías Apague la energia antes de reconectarInstalaciones Especiales Se muestra aquíAjuste Sensibilidad de FotoControl del Tiempo Instale la Tapa de ParedOff Cuando quiere que la luz esté siempre apagada FuncionamientoCómo usar el Control de Luz On Cuando quiere que la luz esté siempre prendidaLa luz no se apaga Investigacion DE AveriasLa luz no se prende El interruptor a control remoto no funcionaLa luz no se queda prendida cuando está en automático Servicio TécnicoLa luz no se prende cuando está en automático La luz se prende durante el día cuando está en auto- máticoEspecificaciones Hasta 400 Vatios Máximo Estabilizador de arranque rápidoGarantía Limitada a 5 Años 595-4514-16-31 Purchase Information Información de la compra