Bulb Installation
NOTE: When
❒To remove lamp shade, loosen set screw 2 full turns with a small
❒To remove bulb, pull straight out of fixture.
❒To replace bulb, push bulb pins into lamp socket. Check that the bulb is seated properly.
❒To reinstall lamp shade, place shade on fixture and align notches on shade with tabs on fixture. Turn clockwise. Tighten set screw firmly.
Mount the Light Control
❒Place the mounting bolt through the front of the junction box cover. Push the small gasket hole over the mounting screw.
❒Make sure the wire connectors and wires are inside the junction box. Align the mounting screw with the center hole in the mounting strap.Secure the fixture to the mounting strap.
❒Push the rubber plug firmly into place.
❒If a wet location junction box was not used, caulk the wall plate mounting surface with silicone weather sealant.
Wire the Light Control
WARNING: Turn power off at circuit breaker or fuse.
❒ Remove the existing light fixture. | |
❒ | Install the mounting strap as shown using two screws |
| that fit your junction box. |
❒ | The plastic hanger can be used to hold the fixture |
| while wiring. The small end of the plastic hanger |
Lamp Shade
Lock Nuts
Set Screw
can be threaded through the hole in the center of |
the cover plate. The small end then goes into one |
of the slots on the mounting strap. |
❒ Route the light control’s wires through the large |
gasket holes. |
❒ Twist the junction box wires and fixture wires together |
as shown. Secure with wire connectors. |
Mounting |
|
|
|
Black to |
| White to | |
Strap | Black |
| White |
|
|
|
|
Rubber
Plug
Gasket |
|
Junction box ground wire to | Mounting |
green ground screw on fixture. | Bolt |
Keep lamps at least 2" (51 mm) from the sensor and 2" (51 mm) from combustibles.
❒Adjust the lamp holders by loosening the lock nuts, but do not rotate the lamp holders more than 180° from the factory setting.
❒Adjust lamp shades by loosening the set screws several turns, turn shades counterclockwise and remove.Reinstall the shades in the desired position and tighten set screws.