INSTALLATION
Installing Logs (Models CCL3018PR, CCL3018NR, CCL3924PR, CCL3924NR, CCL3930PR, AND CCL3930NR) (Cont.)
15
INSTALLATION
Continued
3.Locate pegs on the bottom of back log (#3). Slide these pegs into the holes in the grate base behind the burner (see Figure 26).
4.Locate pegs on the bottom of crossover log (#4). Slide these pegs into the holes located in middle log (#2) and back log (#3). See Figure 27 for placement.
5.Locate pegs on the bottom of crossover log (#5). Slide these pegs into the holes located in crossover log (#4) and front log (#1). See Figure 28.
For CCL3018PR/NR Only: Locate holes on the bottom of cross- over log (#5). Slide the holes over the left pegs on middle log (#2) and front log (#1). See Figure 29.
6.Locate pegs on the bottom of crossover log (#6). Slide these pegs into the holes located in middle log (#2) and front log (#1). See Figure 30.
7.For CCL3930PR/NR only, locate holes on the bottom of cross- over log (#7). Slide onto the pegs located in crossover log (#6) and middle log (#2). See Figure 31.
8.Add lava rock around base of heater if desired. Do not place any lava rock on logs or burner.
Pegs
Crossover Log (#4)
Front Log (#1)
Figure 28 - Installing Crossover Log (#5) (CCL3930PR/NR Shown)
Crossover
Log (#4)
Front Log (#1)
Hole in
Grate
Base
Burner
Figure 26 - Installing Rear Log (#3) (CCL3930PR/NR Shown)
Pegs
Log #2 | Log #3 |
Figure 27 - Installing Crossover Log (#4) (CCL3930PR/NR Shown)
Figure 29 - Installing Crossover Log (#5) (CCL3018PR/PRA and CCL3018NR/NRA Only)
Pegs
6
Log #2
Front Log (#1)
Figure 30 - Installing Crossover Log (#6) (CCL3930PR/NR Shown)
Holes
7
Crossover
Log (#6)
Middle
Log (#2)
Pegs
Figure 31 - Installing Crossover Log (#7) to Models CCL3930PR/PRA and CCL3930NR/NRA Only
For more
visit www.
.com
