Desa CCL3924PRA, CCL3018NRA Installation, Check Gas Type, Minimum Fireplace Clearance To

Page 7
INSTALLATION

INSTALLATION

NOTICE: This heater is intended for use as supple- mental heat. Use this heater along with your primary heating system. Do not install this heater as your primary heat source. If you have a central heating system, you may run system’s circulating blower while using heater. This will help circulate the heat throughout the house. In the event of a power outage, you can use this heater as your primary heat source.

NOTICE: State or local codes may only allow opera- tion of this appliance in a vented configuration. Check your state or local codes.

CHECK GAS TYPE WARNING: A qualified service person must in- stall heater. Follow all local codes.

MINIMUM FIREPLACE WARNING: Make sure the selector switch is in the OFF position before installing heater.

COMBUSTIBLE MATERIALS WARNING: Before installing in a solid fuel burn- ing fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes, and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. A dirty chimney flue may create and distribute soot within the house. Inspect chimney flue for damage. If damaged, repair flue before oper- ating heater.

LOG SIZING REQUIREMENTS WARNING: Seal any fresh air vents or ash clean- out doors located on floor or wall of fireplace. If not, drafting may cause pilot outage or sooting. Use a heat-resistant sealant. Do not seal chimney flue damper.

Manual background WARNING: Never install the heater

•in a bedroom or bathroom unless installed as a vented appliance, see page 10.

•in a recreational vehicle

•where curtains, furniture, clothing, or other flam- mable objects are less than 42 inches from the front, top, or sides of the heater

•in high traffic areas

•in windy or drafty areas

INSTALLATION

7

Check Gas Type

Installation and Clearances

 

 

 

Manual background CAUTION: This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as, but not limited to, tobacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, installing heater in rooms without enough venti- lation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, pages 4 through 6.

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP) for your unit. If your gas supply is not correct, do not install heater. Call dealer where you bought heater for proper type heater.

INSTALLATION AND CLEARANCES (Vent-Free Operation Only)

Manual background WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceil- ing, and adjoining wall.

MINIMUM FIREPLACE

CLEARANCE TO

COMBUSTIBLE MATERIALS

Log Size

Side Wall

Ceiling

ALL

16"

42"

 

 

 

LOG SIZING REQUIREMENTS

Minimum Firebox Size

Log

 

 

Front

Rear

Size Height

Depth

Width

Width*

 

 

 

 

 

18"

17"

13"

28"

20"

24"

17"

13"

28"

21"

30"

17"

13"

34"

24"

 

 

 

 

 

*Measured at 13" depth

Carefully follow the instructions below. This will ensure safe installation into a masonry, UL127-listed manufactured fireplace, or listed vent-free firebox.

For moreManual backgroundManual backgroundManual backgroundvisit www.Manual backgroundManual backgroundManual background.comManual backgroundManual backgroundManual backgroundManual background

111161-01A

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Do not try to light any appliance UNVENTED VENT-FREE GAS LOG HEATERNot Used With Hand-HeldThermostat Remote WHAT TO DO IF YOU SMELL GASSAFETY INFORMATION TABLE OF CONTENTSWARNINGS Continued PRODUCT IDENTIFICATIONSAFETY INFORMATION See Accessories, page PRODUCT FEATURESREMOTE CONTROL ACCESSORIES SAFETY PILOTAIR FOR COMBUSTION AND VENTILATION DETERMINING FRESH-AIRFLOW FOR HEATER LOCATIONUnusually Tight Construction Confined Space and Unconfined SpaceAIR FOR COMBUSTION AND VENTILATION VENTILATION AIRVentilation Air From Inside Building Ventilation Air From OutdoorsCOMBUSTIBLE MATERIALS INSTALLATIONCHECK GAS TYPE MINIMUM FIREPLACE CLEARANCE TOBetween 8 and 12, above. If Minimum Noncombustible Material ClearancesINSTALLATION ContinuedINSTALLATION MANTEL CLEARANCESFLOOR CLEARANCES Determining Minimum Mantel ClearancesChimney INSTALLING HEATER BASE ASSEMBLYINSTALLATION ContinuedInstallation Items Needed CONNECTING TO GAS SUPPLYInstallation Items Needed INSTALLATIONContinued Pressure Testing gas Supply Piping systemCHECKING GAS CONNECTIONS INSTALLATIONContinued INSTALLING REMOTE RECEIVER UNITPressure Testing Heater Gas Connections INSTALLATIONContinued INSTALLING WIRELESS REMOTE CONTROL ACCESSORYInstalling 9-VoltBattery in Receiver INSTALLATIONINSTALLATION INSTALLATIONContinued OPERATING HEATER FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS Shutting Off Heater MANUAL LIGHTING PROCEDURETO TURN OFF GAS TO APPLIANCE OPTIONAL REMOTE OPERATIONMAIN BURNER WIRING DIAGRAMINSPECTING BURNERS PILOT FLAME PATTERNLOGS CLEANING AND MAINTENANCEMAIN BURNER REMEDY TROUBLESHOOTINGOBSERVED PROBLEM POSSIBLE CAUSEOBSERVED PROBLEM Maintenance, pageRefer to Air for Combustion and Venti TROUBLESHOOTINGMaintenance, page ing Gas Connections, pages 12 andTROUBLESHOOTING OBSERVED PROBLEMREPLACEMENT PARTS SPECIFICATIONSSERVICE HINTS TECHNICAL SERVICEILLUSTRATED PARTS BREAKDOWN ILLUSTRATED PARTS BREAKDOWNMODELS CCL3018PR, CCL3018PRA CCL3018NR, CCL3018NRACCL3018PR PARTS LISTPARTS LIST PART NUMBERCCL3930NR, CCL3930NRA MODELSCCL3924PR, CCL3924PRA CCL3924NR, CCL3924NRA CCL3930PR, CCL3930PRAPART NUMBER PARTS LISTFIREPLACE HOOD ACCESSORIESPARTS CENTRAL EQUIPMENT SHUTOFF VALVE GA5010OWNERS REGISTRATION FORM TAPE Postage RequiredTAPE Page COMFORT GLOW VENT-FREEGAS LOG HEATERS WARRANTY INFORMATIONLIMITED WARRANTY NOT A UPC
Top Page Image Contents