OWNER’S MANUAL
INSTALLATION
Continued
Log Piece (#5)
Peg
Figure 29 - Installing Log Piece (#5)
OPERATING
HEATER
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.
A. | This appliance has a pilot which must |
| be lighted by hand. When lighting the |
| pilot, follow these instructions exactly. |
B. BEFORE LIGHTING smell all | |
| around the appliance area for gas. Be |
| sure to smell next to the floor because |
| some gas is heavier than air and will |
| settle on the floor. |
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.
LIGHTING
INSTRUCTIONS
WARNING:
•If fireplace has glass doors, never operate this heater with glass doors closed. If you oper- ate heater with doors closed, heat buildup inside fireplace will cause glass to burst. Also if fireplace opening has vents at the bottom, you must open the vents before operating heater.
•You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.
NOTICE: During initial operation of new heater, burning logs will give off a
Note: Home owners generally prefer to operate their heater with the chimney damper closed. This will put all the heat into the room. However, there may be times you will desire the full flames of the Hi heat setting but will find the heat output excessive. You can open the chimney damper (if you have one) fully or partially to release some of the heat.
WARNING: Damper handle will be hot if heater has been running.
1.STOP! Read the safety information in column 1.
2.Make sure manual shutoff valve is fully open.
3.Set selector switch in the OFF position.
WARNING: Burners will come on automatically within one minute when the remote selector switch is in the ON position after the pilot is lit.
4.Press in and turn control knob clock-
wise 
to the OFF position.
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation, column 1. If you don’t smell gas, go to the next step.
6.Press in and turn control knob coun-
terclockwise 
to the PILOT position. Press in control knob for five (5) seconds (see Figure 30).
Note: You may be running this heater for the first time after hook- ing up to gas supply. If so, the con- trol knob may need to be pressed in for 30 seconds or more. This will al- low air to bleed from the gas system.
WHAT TO DO IF YOU SMELL |
GAS |
• Do not try to light any appliance. |
• Do not touch any electric switch; do |
not use any phone in your building. |
• Immediately call your gas supplier |
from a neighbor’s phone. Follow |
the gas supplier’s instructions. |
• If you cannot reach your gas sup- |
plier, call the fire department. |
| Flame Adjustment Knob |
| Control Knob |
| IH |
|
|
| REMOTE |
| O |
| OFF |
| |
|
| F | |
| ON | N | F |
| O | P | |
| LO |
| LI |
|
| TO | |
Ignitor Button | Selector Switch in OFF Position |
|
|
Figure 30 - Control Knob and Ignitor Button Location |
| Continued | |
105677 | 15 |