OWNER’S MANUAL
INSTALLATION
Continued
Washers | Bottom Of | |
Bolt | Stove Unit | |
Leg | ||
|
Figure 9 - Attaching Stove Legs
10.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Figure 8 on page 8 and Figure 11). Use an ad- justable wrench or a 12mm socket to fas- ten step bolt. Tighten step bolt until snug. Make sure door moves freely.
11.Install door catch bolt (M8 x 1.25- 55mm with two M8 hex nuts) into threaded hole on stove body (see Fig- ure 8, page 8). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.
12.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in nor- mal standing position.
13.Carefully lift stove back up on its four attached legs.
14.Set top grate into stove top.
15.If available, install gas log heater in- side stove cavity before installing the back panel (see Installing Gas Log Heater Into Stove, page 10).
16.Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts and washers. Make sure product identification label is located on the outside in lower left- hand corner.
Stove | Stove |
Door | Door |
Washers
Bolt
Bottom Of
Stove Unit
Stove
Bottom
Figure 10 - Attaching Stove Bottom
Door
Hinge
Step
Bolt
Bolt
Shoulder
Threaded | Bolt |
Hole | Shoulder |
Door
Hinge
Step
Bolt
Stove Bottom
Figure 11 - Attaching Stove Door
Bolt Stop
Adjusting Nut
Door | Door Claw |
Catch Bolt
Figure 12 - Catch Bolt and Door Claw Orientation
Continued
105986 | 9 | For more information, visit www.desatech.com |