Desa VN2550ITA, VN1800ITA, VN1800D, VN3000D Operating Heater, Lighting Instructions

Page 18

OPERATING HEATER

Models VN1800ITA and VN2550ITA

Continued

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information at the top of page 17.

2.Make sure manual shutoff valve is fully open.

3. Turn thermostat control knob on left side of heater clockwise Clockwise to the

OFF position.

Thermostat Control Knob

Ignitor Button

Plaque Control Knob

 

 

 

 

 

 

1

 

 

 

2

PILOT

LO

 

 

OFF

 

 

 

HI

 

 

 

 

 

 

3

 

 

IGNITOR

4

 

 

 

18

Figure 16 - Thermostat Control Knob In The OFF Position

4.Wait five minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information at the top of page 17. If you don’t smell gas, go to the next step.

5.Turn thermostat control knob on left side of heater counterclockwise

C-clockwiseto the PILOT position. Press in thermostat control knob for 5 seconds.

Note: You may be running this heater for the first time after hooking up to gas supply. If so, you may need to press in thermostat control knob for 30 seconds. This will allow air to bleed from the gas system.

•If thermostat control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

6.Keep thermostat control knob pressed in while pushing down and releasing the ignitor button. This will light pilot. If necessary, continue to press ignitor button until pilot lights.

If pilot does not light

•turn thermostat control knob clockwise Clockwise to the OFF position

•repeat steps 5 and 6

If pilot does not stay lit after several tries

•refer to Troubleshooting, pages 26 through 29

•contact a qualified service person or gas supplier

Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 20

7.Keep thermostat control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps 3 through 7. This heater has a safety interlock system. Wait one minute before lighting pilot again.

8.Turn thermostat control knob counterclockwise C-clockwiseto the desired heating level. The plaque directly above the pilot should light.

101822

Page 17 Page 19
Image 18
Page 17 Page 19
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASContents Safety Information Combustion and Ventilation, pages 5 through Local Codes Unpacking Product Features ProductIdentification Ventilation Fresh AIR ForCombustion Producing Adequate VentilationFresh AIR for Combustion and Ventilation Determining FRESH-AIR Flow for Heater LocationDetermining if You Have a Confined or Unconfined Space Ventilation AIR Ventilation Air From Inside BuildingVentilation Air From Outdoors Ventilation Air from OutdoorsCheck GAS Type Installing To WallInstallation Items Locating HeaterLocating Thermostat Sensing Bulb Thermostat Sensing BulbModels VN1800ITA and VN2550ITA Only Attaching Thermostat Sensing BulbRemoving Front Panel Of Heater Installing Heater to WallMounting Bracket Methods For Attaching Mounting Bracket To WallMarking Screw Locations Attaching Mounting Bracket To WallInstalling Bottom Mounting Screws Placing Heater On Mounting BracketConnecting to GAS Supply Connections Pressure Testing GAS Supply Piping SystemChecking GAS Servicing. Correct all leaks at oncePressure Testing Heater GAS Connections Checking GAS ConnectionsOperating Heater Operating Heater Lighting InstructionsHeater To Select Heating LevelShutting Off Heater Shutting Off Burner Only pilot stays litIf you do not follow these instructions exactly, a fire or Explosion may result causing property damage, personalOperating Injury or loss of lifeModels VN1800D and VN3000D LOW MED High Inspecting Burner Pilot Flame PatternBurner Flame Pattern If burner flame pattern is incorrect, as shown in FigureCabinet Cleaning and Maintenance Trouble ShootingODS/PILOT and Burner Orifice Air PassagewaysObserved Possible Remedy Problem Cause TROUBLE- ShootingTrouble Shooting See CleaningDo not try to light any appliance If you smell gasShut off gas supply Ing statement atTechnical Service Service Publications HintsVN1800D VN3000D Replacement Parts AccessoriesIllustrated Parts Breakdown Model VN1800ITAParts List Model VN2550ITA Parts List Model VN1800D Control Position Label Hardware Assembly Model VN3000D Parts List Warranty Information Keep this Warranty
Top Page Image Contents