Desa VN1800D, VN1800ITA Placing Heater On Mounting Bracket, Installing Bottom Mounting Screws

Page 13

INSTALLING TO WALL

Continued

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings. IMPORTANT: Do not hammer key!

For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

Figure 10 - Popping Open Anchor Wings For Thin Walls

5.Place mounting bracket onto wall. Line up last hole on each end of bracket with wall anchors.

6.Insert mounting screws through bracket and into wall anchors.

7.Tighten screws until mounting bracket is firmly fastened to wall.

Placing Heater On Mounting Bracket

1.Locate two horizontal slots on back panel of heater.

2.Place heater onto mounting bracket. Slide horizontal slots onto stand-out tabs on mounting bracket.

Horizontal Slots

Stand-Out Tab

Mounting Bracket (attached to wall)

Figure 11 - Mounting Heater Onto Mounting Bracket

Installing Bottom Mounting Screws

1.Locate two bottom mounting holes. These holes are near bottom on back panel of heater (see Figure 14).

2.Mark screw locations on wall.

3.Remove heater from mounting bracket.

4.If installing bottom mounting screws into hollow or solid wall, install wall anchors. Follow steps 1 through 4 under Attaching To Wall Anchor Method, page 12.

If installing bottom mounting screw into wall stud, drill holes at marked loca- tions using 9/64" drill bit.

5.Replace heater onto mounting bracket.

6.Place spacers between bottom mounting holes and wall anchor or drilled hole.

7.Hold spacer in place with one hand. With other hand, insert mounting screw through bottom mounting hole and spacer. Place tip of screw in opening of wall anchor or drilled hole.

8.Tighten both screws until heater is firmly secured to wall. Do not over tighten. Note: Do not replace front panel at this time. Replace front panel after making gas connections and checking for leaks (see pages 14-16).

Figure 12 - Installing Bottom Mounting Screws

101822

13

Image 13

Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information Combustion and Ventilation, pages 5 through Product Local Codes Unpacking Product FeaturesIdentification Combustion Fresh AIR ForVentilation Producing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Fresh AIR for Combustion and VentilationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRVentilation Air from Outdoors Ventilation Air From OutdoorsInstallation Items Installing To WallCheck GAS Type Locating HeaterModels VN1800ITA and VN2550ITA Only Thermostat Sensing BulbLocating Thermostat Sensing Bulb Attaching Thermostat Sensing BulbMounting Bracket Installing Heater to WallRemoving Front Panel Of Heater Methods For Attaching Mounting Bracket To WallAttaching Mounting Bracket To Wall Marking Screw LocationsPlacing Heater On Mounting Bracket Installing Bottom Mounting ScrewsConnecting to GAS Supply Checking GAS Pressure Testing GAS Supply Piping SystemConnections Servicing. Correct all leaks at onceChecking GAS Connections Pressure Testing Heater GAS ConnectionsOperating Heater Lighting Instructions Operating HeaterTo Select Heating Level HeaterShutting Off Burner Only pilot stays lit Shutting Off HeaterOperating Explosion may result causing property damage, personalIf you do not follow these instructions exactly, a fire or Injury or loss of lifeModels VN1800D and VN3000D LOW MED High Pilot Flame Pattern Inspecting BurnerIf burner flame pattern is incorrect, as shown in Figure Burner Flame PatternODS/PILOT and Burner Orifice Cleaning and Maintenance Trouble ShootingCabinet Air PassagewaysTROUBLE- Shooting Observed Possible Remedy Problem CauseSee Cleaning Trouble ShootingShut off gas supply If you smell gasDo not try to light any appliance Ing statement atService Publications Hints Technical ServiceVN1800D VN3000D Accessories Replacement PartsModel VN1800ITA Illustrated Parts BreakdownParts List Model VN2550ITA Parts List Model VN1800D Control Position Label Hardware Assembly Model VN3000D Parts List Keep this Warranty Warranty Information