Desa VN3000D, VN1800ITA, VN1800D, VN2550ITA Ventilation AIR, Ventilation Air From Inside Building

Page 7

FRESH AIR FOR COMBUSTION AND VENTILATION

Continued

WARNING

WARNING ICON

G 001

If the area in which the heater may be operated is smaller than that defined as an unconfined space, provide adequate combus- tion and ventilation air by one of the methods described in the National Fuel Gas Code, ANSI Z223.1, 1992, Section 5.3.

VENTILATION AIR

Ventilation Air From Inside Building

This fresh air would come from an adjoining unconfined space. When ventilating to an adjoining unconfined space, you must provide two permanent openings: one within 12" of the ceiling and one within 12" of the floor on the wall connecting the two spaces (see options 1 and 2, Figure 2). You can also remove door into adjoining room (see option 3, Figure 2). Follow the National Fuel Gas Code NFPA 54/ANSI Z223.1, Section 5.3, Air for Combustion and Ventilation for required size of ventilation grills or ducts.

WARNING

WARNING ICON

G 001

 

 

Rework worksheet, adding the space of the adjoining unconfined space. The combined spaces must have enough fresh air to supply all appliances in both spaces.

Ventilation

 

Grills

Or

into Adjoining

Remove

Room,

Door into

Option 1

Adjoining

 

Room,

 

Option 3

12"

Ventilation Grills

Into Adjoining Room,

Option 2

12"

Figure 2 - Ventilation Air from Inside Building

Continued

101822

7

Image 7
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information Combustion and Ventilation, pages 5 through Product Local Codes Unpacking Product FeaturesIdentification Producing Adequate Ventilation Fresh AIR ForCombustion VentilationDetermining FRESH-AIR Flow for Heater Location Fresh AIR for Combustion and VentilationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRVentilation Air from Outdoors Ventilation Air From OutdoorsLocating Heater Installing To WallInstallation Items Check GAS TypeAttaching Thermostat Sensing Bulb Thermostat Sensing BulbModels VN1800ITA and VN2550ITA Only Locating Thermostat Sensing BulbMethods For Attaching Mounting Bracket To Wall Installing Heater to WallMounting Bracket Removing Front Panel Of HeaterAttaching Mounting Bracket To Wall Marking Screw LocationsPlacing Heater On Mounting Bracket Installing Bottom Mounting ScrewsConnecting to GAS Supply Servicing. Correct all leaks at once Pressure Testing GAS Supply Piping SystemChecking GAS ConnectionsChecking GAS Connections Pressure Testing Heater GAS ConnectionsOperating Heater Lighting Instructions Operating HeaterTo Select Heating Level HeaterShutting Off Burner Only pilot stays lit Shutting Off HeaterInjury or loss of life Explosion may result causing property damage, personalOperating If you do not follow these instructions exactly, a fire orModels VN1800D and VN3000D LOW MED High Pilot Flame Pattern Inspecting BurnerIf burner flame pattern is incorrect, as shown in Figure Burner Flame PatternAir Passageways Cleaning and Maintenance Trouble ShootingODS/PILOT and Burner Orifice CabinetTROUBLE- Shooting Observed Possible Remedy Problem CauseSee Cleaning Trouble ShootingIng statement at If you smell gasShut off gas supply Do not try to light any applianceService Publications Hints Technical ServiceVN1800D VN3000D Accessories Replacement PartsModel VN1800ITA Illustrated Parts BreakdownParts List Model VN2550ITA Parts List Model VN1800D Control Position Label Hardware Assembly Model VN3000D Parts List Keep this Warranty Warranty Information