Desa VN3000D, VN1800D Installing Heater to Wall, Mounting Bracket, Removing Front Panel Of Heater

Page 11

INSTALLING	INSTALLING HEATER TO WALL
TO WALL	Mounting Bracket
TO WALL	The mounting bracket is located on back panel of heater. It has been taped there for
Continued	shipping. Remove mounting bracket from back panel.

Mounting

Bracket

Figure 6 - Mounting Bracket Location

Removing Front Panel Of Heater

1.Remove two screws near bottom corners of front panel.

2.Lift straight up on grill guard until it stops. Grill guard will slide up about 1/4".

3.Pull bottom of front panel forward, then down.

Figure 7 - Removing Front Panel Of Heater

Methods For Attaching Mounting Bracket To Wall

Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways.

1.Attaching to wall stud

2.Attaching to wall anchor

Attaching to wall stud This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.

Attaching to wall anchor This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).

Decide which method better suits your needs. Either method will provide a secure

hold for the mounting bracket.

101822

Continued 11

Image 11

Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information Combustion and Ventilation, pages 5 through Identification Local Codes Unpacking Product FeaturesProduct Producing Adequate Ventilation Fresh AIR ForCombustion VentilationDetermining if You Have a Confined or Unconfined Space Fresh AIR for Combustion and VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRVentilation Air from Outdoors Ventilation Air From OutdoorsLocating Heater Installing To WallInstallation Items Check GAS TypeAttaching Thermostat Sensing Bulb Thermostat Sensing BulbModels VN1800ITA and VN2550ITA Only Locating Thermostat Sensing BulbMethods For Attaching Mounting Bracket To Wall Installing Heater to WallMounting Bracket Removing Front Panel Of HeaterAttaching Mounting Bracket To Wall Marking Screw LocationsPlacing Heater On Mounting Bracket Installing Bottom Mounting ScrewsConnecting to GAS Supply Servicing. Correct all leaks at once Pressure Testing GAS Supply Piping SystemChecking GAS ConnectionsChecking GAS Connections Pressure Testing Heater GAS ConnectionsOperating Heater Lighting Instructions Operating HeaterTo Select Heating Level HeaterShutting Off Burner Only pilot stays lit Shutting Off HeaterInjury or loss of life Explosion may result causing property damage, personalOperating If you do not follow these instructions exactly, a fire orModels VN1800D and VN3000D LOW MED High Pilot Flame Pattern Inspecting BurnerIf burner flame pattern is incorrect, as shown in Figure Burner Flame PatternAir Passageways Cleaning and Maintenance Trouble ShootingODS/PILOT and Burner Orifice CabinetTROUBLE- Shooting Observed Possible Remedy Problem CauseSee Cleaning Trouble ShootingIng statement at If you smell gasShut off gas supply Do not try to light any applianceVN1800D VN3000D Technical ServiceService Publications Hints Accessories Replacement PartsModel VN1800ITA Illustrated Parts BreakdownParts List Model VN2550ITA Parts List Model VN1800D Control Position Label Hardware Assembly Model VN3000D Parts List Keep this Warranty Warranty Information