OPERATING HEATER
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be purchased separately (see Accessories, pages 29). Follow instructions included with the re- mote control.
NOTICE: You must light the pilot before using the
After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 30). Note: The burner may light if
IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.
TO LOCK press both buttons on
THERMOSTAT SERIES (MODEL | |
GHRCTB) |
|
The | |
either the manual mode (MANU) or thermo- | |
static mode (AUTO) (see Figure 32). To select | |
Fahrenheit/Centigrade mode display, carefully | |
press the ˚C/˚F mode button with the end of a | |
paper clip or similar blunt object. | |
Digital | Turns Hand- |
Display | Held Remote |
Shows | On or Off and |
Temperature | Allows You |
and Settings | to Choose |
| the Manual |
Turns | Setting |
Burners On |
|
or Off | Selects Auto |
| Setting |
Flame Adjustment
Control Knob in Knob
On Position
| F | PIL |
|
|
|
|
|
| OT | H |
|
|
|
| |
O | F |
|
|
|
|
| |
| O | I | O | REMOTE | OFF | ON | |
|
| N |
| ||||
|
|
|
| L |
|
|
|
Selector Switch in Remote Position
Decreases | |
Room |
|
Temperature | |
in AUTO |
|
Mode | Locks System to |
| |
| Prevent Accidental |
| Ignition |
Increases
Room
Temperature
in AUTO
Mode
Figure 30 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the
Control Button
Turns Burners
On and Off
Figure 31 - On/Off Hand-Held Remote Control Unit (GHRCB)
Figure 32 - Thermostat Hand-Held Remote Control Unit (GHRCTB)
Manual Mode
1.Press the POWER and LOCK buttons together to turn on the
2.Press the MANU button to turn on the fireplace.
3.Press the POWER and LOCK buttons together to turn off the fireplace.
Auto (Thermostatic) Mode
1.Press the POWER and LOCK buttons together to turn on the
2.Press AUTO button to select this mode.
3.Set the desired room temperature by press- ing the TEMP + or - buttons.
www.desatech.com | 21 |